SHIPPING STANDS
Page 5-7 Apr 11/2002 D623N005
 

5.4 DESIGN LOADS
5.4.1 Design Loads Definition
The allowable handling loads for the engine structure are shown in Figure 5-5 through Figure 5-9. The engine fan case-to-stand adapters (Figure 5-10) is designed to shield the fan case from excess moment inputs and limit the transport loads to the allowable handling loads. The rear support adapter does not impose axial loads on the engine.
5-4-1

DESIGN LOADS
Page 5-8 Apr 11/2002 D623N005
 

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 5-5 PRIMARY FRONT GROUND HANDLING -SIDE PICKUP

5-4-1

DESIGN LOADS
Page 5-9 Apr 11/2002 D623N005
 

Flagnotes 1-4 below refer to the previous figure.
[1] SEE Figure 5-6
[2] SEE Figure 5-8
[3] SEE Figure 5-9
[4] PADS MUST BE USED IN PAIRS
4,300 LB (1950 KG) THE SUM OF 5,000 LB (2268 KG) FOR EACH SIDE; LEFT AND RIGHT PAD PAIRS MUST BE LOADED EQUALLY
5-4-1

DESIGN LOADS Page 5-10 Apr 11/2002
D623N005

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 5-6 SECONDARY FRONT GROUND HANDLING -TOP PICKUP

5-4-1

DESIGN LOADS
Page 5-11 Apr 11/2002 D623N005
 

NOTE: (From P&WA Drawing No. 1A3604)
Figure 5-7 ALLOWABLE LIMITS
1.11  Primary handling pads must be used for shipping.
1.10  Under &9A ultimate G load condition, both front and rear supports must take out axial load. A deflection of .100 inches(2.54 millimeters) between the front and rear handling planes is acceptable before the rear fittings are loaded. All four supports combined provide a G load capability.
1.9  No side load is permitted using secondary handling methods.
1.8  Allowable loads on this drawing reflect the load capabilities of the engine hardware and are not intended to be design loads or load capabilities of ground handling fixtures.
1.7  Supports for the ground handling points must be symmetrical about the vertical engine centerline. The engine must not be rotated about the axial engine centerline during handling or shipping.
1.6  Allowable loads and offsets are based on a total engine weight of 8,800 lb (3992 kg) (including inlet cowl, exhaust nozzle and tail plug attached). CG located at Sta 119.320.
1.5  The horizontal front ground handling configuration meets either the &9A ultimate G load condition with appropriate moment arm restrictions or &5V ultimate crash load condition.
1.4  The shipping and ground handling (excluding hoisting) allowable limit loads meet the following G load
specs: 
Ground Handling  Shipping 
±3.0V  ±3.0V 
±1.5S ±1.5V  ±1.5S 
±2.0A ±1.5V  ±3.0A 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 PW2000 Series Engine Ground Handling Document 發動機地面處理文件(19)