曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

2. Obtain blanking plate (213T2412-1) or manufacture per the following:
Blanking Plate Specifications (Dimensions in Inches)
3. Provide electrical power (AMM 24-22-00/201).
WARNING: REMOVE PRESSURE FROM THE PNEUMATIC SYSTEM. PRESSURE IN THE PNEUMATIC SYSTEM CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 
4. Remove pressure from the pneumatic system (AMM 36-00-00).
5. Place both air conditioning pack control selectors on pilot's overhead panel P5 in OFF position. Attach DO-NOT-OPERATE identifier to both selectors.
6. Lower left(right) air conditioning pack access door 193HL(194ER).
7. Loosen clamp on downstream side of the left (or right) trim air check valve and slide clamp along duct.
TRIM AIR SUPPLY CHECK VALVE INSTALLATION
8. Slip blanking plate between duct assembly and trim air check valve.
9. Reinstall clamp. Torque clamp nut to 45 inch-pounds.
10. Perform leakage test per the following:
A. Provide pneumatic power (AMM 36-00-00).
B. Remove DO-NOT-OPERATE identifier from both air conditioning pack control selectors on P5 panel, and place both selectors to AUTO position.
 
C. Press TRIM AIR switchlight, on P5 panel, to OFF position. Remove DO-NOT-OPERATE identifier from switchlight.
D. Check valve flange for leakage.
1) Diffused leakage is acceptable.
2) Jet blast leakage must be repaired by joint or clamp realignment. 11. Put the airplane back to its usual condition:
A. Close left(right) air conditioning pack access door 193HL(194ER).
B. Remove pneumatic power (AMM 36-00-00).
C. Remove electrical power (AMM 24-22-00/201).
 
NUMBER INSTALLED

  NUMBER REQUIRED FOR DISPATCH
3 0 REMARKS OR EXCEPTIONS

 
NOTE: 757-200 airplanes have COMPT TEMP indications for FLT DK, FWD, and AFT control zones. EICAS STATUS MESSAGES
None
PLACARD
Associated indication as appropriate
 

 
EICAS STATUS MESSAGES
None
PLACARD
Autopilot Mode Control Panel as appropriate - L(C,R) AUTOPILOT INOP
MAINTENANCE (M)
1. Autopilot Inoperative, Autopilot Electrohydraulic Servo Valves (EHSV) Not Leaking:
A. Verify minimum number of FCC 115 VAC circuit breakers on the P11 overhead panel are closed for dispatch configuration. Dispatch is allowed if an inoperative FCC has a fault that trips its circuit breaker provided the minimum number of FCC circuit breakers are closed, however sensor data availability is maximized if all FCC breakers are closed.
1) FLT CONT CMPTR PWR L
2) FLT CONT CMPTR PWR C
3) FLT CONT CMPTR PWR R
B. Open and collar FCC 28 VDC servo circuit breaker on the P11 overhead panel for the failed autopilot channels:
1) FLT CONT CMPTR SERVO L
2) FLT CONT CMPTR SERVO C
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 最低設備清單 Minimum Equipment List (MEL) 1(52)