S 865-765
 (65)
 Put the safety-sensitive systems back to their initial conditions (AMM 32-09-02/201).

 S 865-013

 (66)
 Set the parking brake to the OFF position.

 S 865-766

 (67)
 Make sure that this P11 panel circuit breaker is closed:

 (a)  
GUN 001-010, 101-104 POST-SB 27-104;
 GUN 011-100, 105-999;
 11C5, STAB TRIM LEFT CONT

 (b)  
GUN 001-010, 101-104 PRE-SB 27-104;
 11H11, STAB TRIM LEFT CONT

 S 865-767
 (68)
 Make sure the C STAB TRIM switch on the aisle control stand is in the NORM position.

 S 865-768

 (69)
 Put the R STAB TRIM switch on the aisle control stand in the CUT OUT position.

 S 865-769

 (70)
 Use the control wheel STAB TRIM controls to move the stabilizer such that dimension B is between 15 and 21 inches (AMM 27-48-00/501).

 S 865-770

 (71)
 Hold the CONFIG switch on the TEST panel in the T/O position.

 (a)  
Make sure the red CONFIG light is not on.

 (b)  
Make sure the WARNING lights are not on.

 (c)  
Make sure the siren aural warning is not on.

 (d)  
Make sure the red EICAS message, STABILIZER, does not show on the top display.

 S 865-771
 (72) Slowly move the control wheel STAB TRIM controls up until the takeoff configuration warnings come on.
 (a)  Measure dimension B on the ballscrew actuator
 (AMM 27-48-00/501).

  ú

 31-51-00
 ALL  ú ú 08 Page 551 ú Sep 28/00

A

757
MAINTENANCE MANUAL

 (b)  Make sure that dimension B is 22.76 (+.30/-.20) inches.
 S 865-772
 (73) Use the control wheel STAB TRIM controls to move the stabilizer such that dimension B is between 15 and 21 inches.
 (a)  Make sure the takeoff configuration warnings are not on.
 S 865-773
 (74) Slowly move the control wheel STAB TRIM controls down until the takeoff configuration warnings come on.
 (a)  
Measure dimension B on the ballscrew actuator
 (AMM 27-48-00/501).

 (b)  
Make sure that dimension B is 13.78 (+.20/-.30) inches.

 S 865-023
 (75) Use the control wheel STAB TRIM controls to move the stabilizer such that dimension B is between 15 and 21 inches.
 (a)  Make sure the takeoff configuration warnings are not on.
 S 865-024
 (76)
 Release the CONFIG switch.

 S 865-774

 (77)
 Set the parking brake to the ON position.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 2(131)