(b)
Make sure the red EICAS message, PARKING BRAKE, does not show on the top display.
NOTE: The yellow EICAS message, PARKING BRAKE, may show on the
____
top display.
S 865-736
(13)
Release the CONFIG switch.
S 865-737
(14)
Close this P11 panel circuit breaker:
(a) 11C30, LANDING GEAR POS SYS 1
S 865-738
(15)
Hold the CONFIG switch on the TEST panel in the T/O position.
(a)
Make sure the red CONFIG light comes on.
(b)
Make sure that the WARNING lights come on.
(c)
Make sure the siren aural warning comes on.
(d)
Make sure the red EICAS message, PARKING BRAKE, shows on the top display.
(16)
Release the CONFIG switch.
S 865-740
(17)
Open this P11 panel circuit breaker:
S 865-739
(a) 11S15, LANDING GEAR AIR/GND SYS 1
S 865-741
(18) Hold the CONFIG switch on the TEST panel in the T/O position.
(a) Make sure the red EICAS message, PARKING BRAKE, does not show on the top display.
ú
31-51-00
ALL ú ú 01 Page 534 ú Jan 20/99
A
757
MAINTENANCE MANUAL
S 865-742
(19)
Release the CONFIG switch.
S 865-743
(20)
Close this P11 panel circuit breaker:
(a) 11S15, LANDING GEAR AIR/GND SYS 1
S 865-624
(21)
Put the safety-sensitive systems back to their initial conditions (AMM 32-09-02/201).
S 865-012
(22)
Set the parking brake to the OFF position.
S 865-625
(23)
Make sure that this P11 panel circuit breaker is closed:
(a)
GUN 001-010, 101-104 POST-SB 27-104;
GUN 011-100, 105-999;
11C5, STAB TRIM LEFT CONT
(b)
GUN 001-010, 101-104 PRE-SB 27-104;
11H11, STAB TRIM LEFT CONT
S 865-626
(24)
Make sure the C STAB TRIM switch on the aisle control stand is in the NORM position.
S 865-627
(25)
Put the R STAB TRIM switch on the aisle control stand in the CUT OUT position.
S 865-628
(26)
Use the control wheel STAB TRIM controls to move the stabilizer such that dimension B is between 15 and 21 inches (AMM 27-48-00/501).
S 865-629
(27)
Hold the CONFIG switch on the TEST panel in the T/O position.
(a)
Make sure the red CONFIG light is not on.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 2(122)
