S 865-819

 (63)
 Put the FLAP lever in the 5-unit position.

 S 865-820

 (64)
 Make sure that the flaps and slats do not move.

 S 865-821

 (65)
 Put the LE switch in the NORM position to deactivate the LE slats electric drive.

 NOTE:____The flaps will move to the 5-unit position. The slats will move to the intermediate position.
 S 865-822
 (66) Put the ALTN FLAPS control in the NORM position.
 P. Takeoff Configuration Warning Signals Test (Continued)
 S 865-828
 (1)  Close these P11 panel circuit breakers:
 (a)  11C14, FLAP/SLAT ELEC UNIT 2 POWER
  ú

 31-51-00
 ALL  ú ú 03 Page 532 ú May 28/99

A

757 MAINTENANCE MANUAL
 (b) (c)  11C15, FLAP/SLAT ELEC UNIT 2 CONT11C16, FLAP/SLAT ELEC UNIT 2 SENSOR
 (2)  S 865-723Make sure that the SPEED BRAKE lever is in the DOWN position.
 (3)  S 865-724Hold the CONFIG switch on the TEST panel in the T/O position. (a) Make sure the red EICAS message, SPOILERS, does not show on the top display when the EICAS COMPUTER switch is in the L and R positions.
 NOTE:____ The yellow EICAS message, SPOILERS, may show on the top display if there is a fault in the spoiler system.
 (4)  S 865-725Release the CONFIG switch.
 (5)  S 865-726Put the SPEED BRAKE lever in the UP position.
 (6)  S 865-727Hold the CONFIG switch on the TEST panel in the T/O position. (a) Make sure the red CONFIG light comes on. (b) Make sure the WARNING lights come on. (c) Make sure the siren aural warning comes on. (d) Make sure the red EICAS message, SPOILERS, shows on the top display when the EICAS COMPUTER switch is in the L and R positions.
 (7)  S 865-728Release the CONFIG switch.
 (8)  S 865-729Put the SPEED BRAKE lever in the DOWN position.
 (9)  S 865-730Set the parking brake to the ON position.

  ú

 31-51-00
 ALL  ú ú 03 Page 533 ú May 28/99

A
757
MAINTENANCE MANUAL

 S 865-731
 WARNING: PREPARE THE SAFETY-SENSITIVE SYSTEMS FOR THE AIR MODE BEFORE
_______ YOU OPEN THE AIR/GROUND CIRCUIT BREAKERS. IN THE AIR MODE, MANY OF THE AIRPLANE SYSTEMS CAN OPERATE AND CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
 (10)
 Prepare the safety-sensitive systems for air mode simulation (AMM 32-09-02/201).

 S 865-734

 (11)
 Open this P11 panel circuit breaker:

 (a)  11C30, LANDING GEAR POS SYS 1
 S 865-735
 (12) Hold the CONFIG switch on the TEST panel in the T/O position.
 (a)  
Make sure the siren aural warning is not on.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機(jī)維護(hù)手冊 儀表 CHAPTER 31 - INSTRUMENTS 2(121)