曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費(fèi)者

The headrest may be adjusted manually by sliding the headrest up or down as required. A friction device ensures that the headrest remains in the chosen position.
The headrest ears can be adjusted manually by rotating the ears to the required position. Again, friction ensures that the ears remain in the chosen position.
C. Foodtray Deployment
Open the endbay/console armcap, and pull on the foodtray handle to rotate the table to its vertical position. The table can now be swung into its deployed position ready for use. Close the armcap.
In the deployed position, the foodtray can slide forward and aft to allow for passenger comfort. The table is bi-fold, and can be used with either one or two leaves opened, as required.
D. Attachment of the Seat Assembly
The seat assembly is attached to the aircraft seat tracks by securing the legs, fore and aft, with studs and track fittings.
Page 12
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

TESTING AND FAULT ISOLATION
1.  
Proper Assembly

Proper assembly of the passenger seat will preclude the necessity for elaborate testing procedures. Complete disassembly of the seat is not usually required. Disassembly should proceed only so far as to correct malfunctions or replace damaged and worn parts. After assembly check all seat functions to ensure that each performs smoothly with no excessive binding or other evidence of faulty assembly.

2.  
Seat Back Recline Mechanism

Seat backs recline through the operation of a recline control button with pressure applied in an aft direction on the back. When the recline control button is pushed with no pressure exerted on the back, the seat should return to its full upright position. If the seat back fails to operate in the above fashion, refer to REPAIR (Page Block 6000) for corrective action. Refer to the envelope drawings in this CMM for recline operation.
On mechanical locks, check clutch engagement in the recline lock by placing the seat back in the upright position and applying pressure in an aft direction. If the seat back reclines slightly and a click is audible, refer to REPAIR (Page Block 6000).
3.  
Breakover Seat backs are locked out from breakover by the use of a nut and bolt.

4.  
Seat Attachment to Aircraft

The seat assemblies should lock securely to the floor track at the lock mechanisms and studs at the bottom of the leg assemblies. If the lock mechanisms or studs do not lock firmly into the floor tracks, refer to FITS AND CLEARANCES (Page Block 8000).

5.  
Fault Isolation Table 1001 consists of three columns:

A. FAULT - Defines the problem.
B. PROBABLE CAUSE AND FAULT ISOLATION - Defines the most likely cause of the problem.
C. CORRECTIVE ACTION - Provides the corrective action to be taken in the order that would most likely correct the problem.
Page 1001
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(8)