ITEM  DESCRIPTION  ITEM  DESCRIPTION 
1  Fabric support (non-procurable)  3  Valve actuator assembly 
2  Bladder - lumbar, side valve 

NOTE: For specific parts information, see IPL Figure 1.
Page 6005
25-26-87 May 25, 2011
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

(1)  To remove lumbar cushion assembly (Refer to Figure 6002)
The lumbar cushion assembly, P/N 48210213 (Longhaul), consists of fabric support (non-procurable part), lumbar bladder, and valve actuator assembly.
(a)  
Remove the fabric support (1) from lumbar bladder (2) by unfastening hook-and-pile.

(b)  
Remove the valve actuator assembly (3) from bladder by pulling out the valve actuator to overcome the friction seal of the lumbar bladder.

NOTE:  Older style lumbar valve assemblies (as pictured) are no longer available from the manufacturer. New replacement valve assemblies are modular and do not disassemble.
(2)  To install lumbar cushion assembly (Refer to Figure 6002)
(a)  
Install valve actuator assembly (3) into lumbar bladder (2) by pushing the valve actuator assembly into the bladder actuator opening located on the side of the bladder. Apply sufficient pushing force so as to allow a friction seal to occur.

NOTE:  Failure to properly install the valve actuator assembly (3) into the bladder may cause the lumbar cushion assembly not to operate properly.

(b)  
Restore to operation and test function.

D. Remove and Install Recline Control Hydrolok and Adjust Back Recline
Page 6006
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

2
12
11
1
4
3
5
6
7
8
9
10

Figure 6004 - Back Recline Hydrolok Procedures
Table 6005
Recline Control hydrolok Components

ITEM DESCRIPTION ITEM DESCRIPTION 1
Screw 7
Washer
2

Recline arm 8
Washer
3

Washer 9
Jam nut
4

Nut 10
Actuator
5

Recline lock 11
Bracket
6

Jam nut 12
Spreader NOTE: For specific part information, see IPL Figures 3 and 4.
Page 6007
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

(1)  
To remove recline lock (Refer Figure 6004)

(a)  
Place the seat in the fully upright position to remove tension from the
recline lock (5).

(b)  
Remove the clip on the actuator (10) from the threaded end of the recline lock (5). Retain for reuse.

(c)  
Remove screw (1), washer (3), and nut (4) securing recline lock (5) to recline arm (2). Retain for reuse.
　
中國(guó)航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(33)