Page 14007
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

Table 14004 (Continued) Light Check Tasks
TASK  TIME REQUIRED 
7  Back Assemblies and Installation (Refer to IPL Figures 3 and 4) 
Ensure literature pocket springs are secure and correctly fitted. Replace as necessary. 
Check/tighten all loose bolts and nuts, paying particular attention to the hydrolok and recline arm installation. Replace any worn or damaged items. 
Check all hydrolok and recline control mechanical cables. Replace any found defective. 
Adjust seat controls, as required, by adjusting the cable jam nuts. Refer to REPAIR (Page Block 6000). 
Set the seat backs in line to the dimensions shown in DESCRIPTION AND OPERATION. 
8  Endbay Assemblies (Refer to IPL Figures 9, 10, 11, and 12) 
Replace all damaged or excessively worn armcap assemblies. 
Check/tighten all screws and bolts. 
Ensure there are no rough edges on screws, etc. Blend as necessary. 
Check armcap hinges for loose screws and damage. Repair/replace as necessary. 
Check front and rear escutcheons for security/ damage. Replace as necessary. 
Check all shrouds for damage. Repair/replace as necessary. 
Check front and side shrouds for secure installation. Replace plastic rivets as necessary. 
Check function of in-arm foodtray, paying particular attention to table link pins and linkages. 
Examine all in-arm foodtray laminates. Repair/ replace any damaged in-arm foodtray. 
Check in-arm foodtray alignment. If out of alignment, set by adjusting set screws. 

Page 14008
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL MILLENNIUM. 88813 SERIES
D. Heavy Check - Out of Aircraft
The Heavy Check includes all previous checks plus some additional checks. (Refer to Table 14005.)
Table 14005 Heavy Check Tasks
TASK  TIME REQUIRED 
1  Preparation and Cleaning Procedure 
Carry out a visual examination of the complete seat assembly (Refer to IPL Figure 1). Thoroughly inspect all components, assemblies, and subassemblies using a strong light and some means of magnification. Examine parts for cuts, nicks, cracks, corrosion, scoring, damaged threads, excessive wear, and any defects that may impair the efficient operation of the seat. 
2  Seat Covers and Cushions (Refer to IPL Figure 1) 
Test seat covers for continued flame retardancy. NOTE: Repetitive cleaning and buildup of foreign substances in covers will adversely affect flame retardancy of covers over time. Cover appearance may be adequate while actual serviceability no longer meets regulatory requirements. 
　
中國(guó)航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(77)