曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

19) Adjust the tension of the cable assembly — refer to Page 501.
20) Make sure all the tools and materials are removed and the work area is clean and free from debris.
21) Close "AP CMPTR" and "AP SERVOS" circuit breakers.
22) Perform the tests specified in HONEYWELL Installation and Maintenance Manual, P/N 006-00776-0000 Paragraph 6 section "KFC 225 Maintenance Matrix".
AAAA
Validity : KFC 225 KS 272C 22-12-06Page 403
(BA) NOV 01
 
1 - Bolt
2 - Washer
3 - Bolt
4 Washer
5 - Bolt
6 Washer
7 - Pulley support flange
8 - Idle pulley
9 - Nut
10 - Mounting plate
11 - Nut
12 B38 pitch trim servo actuator
13 - Connector
14 Bolt
15 - Bolt
16 - Pulley support assembly
17 - Guard
18 - Washer
19 - Bolt
20 - Captive nut
21 - Bolt
B38 pitch trim servo actuator — Removal / Installation
Key to Figure 401
WA
Validity : KFC 225 KS 272C 22 12 06Page 404
(BA) NOV 01
 
 
 

 
 
B38 pitch trim servo actuator — Removal / Installation
Figure 401
 
7 - Pulley support flange
31- Pulley
32- Cable clamp
33- Support
34- Cable assembly
35- Threaded end
36- Turnbuckle barrel
37- Threaded end
38- Rear spool
39- Drive capstan
40- Guard
41- Bolt
42- Washer
43- Immobilization tool
B38 pitch trim servo actuator — Removal / Installation
Key to Figure 402
WA
Validity : KFC 225 KS 272C
12-06 Page 406
22
(BA) NOV 01
 
 
 
B38 pitch trim servo actuator — Removal / Installation
Figure 402
 
PAGE INTENTIONALLY LEFT BLANK
WA
Validity : KFC 225 KS 2720
22-12-06Page 408
(BA) NOV 01
 
B38 PITCH TRIM SERVO ACTUATOR
ADJUSTMENT/TEST
1. CABLE TENSION ADJUSTMENT (Figure 501)
A. Tool and consumable materials
- Tensiometer P/N ZO0.N6068707229
- Stainless steel lockwire dia. 0.031 in (0.8 mm)
- Immobilization tool P/N T700A2799000009
B. Procedure
1) Make sure that the main switch-breaker is open.
2) Install the warning sign prohibiting main switch-breaker operation.
WARNING
DO NOT OPERATE
MAINTENANCE WORK IN PROGRESS
3) Open "AP CMPTR" and "AP SERVOS" circuit breakers located on the circuit breaker panel.
4) Open baggage compartment door 219 and remove compartment bottom door 242.
5) Cut if necessary the lockwire of the turnbuckle barrel (1).
6) Set the trim tab control to neutral position.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 22 AUTO FLIGHT TB20飛機維護手冊 22 自動飛行(54)