曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

7 - Torque wrench
8 - Nut (friction adjustment)
9 - Drive capstan
 
Servo actuator clutch friction torque - Adjustment / Test
Figure 501
I AAAA
Validity KFC 225 22-12-00Page 506
(BA) JUN 04
 
A82 FLIGHT COMPUTER
REMOVAL / INSTALLATION
1. REMOVAL OF A82 FLIGHT COMPUTER
A. Tool and consumable material
- Wrench Allen 3/32 in
- Grease (TB 04-900)
B. Removal of flight computer (Figure 401)
1) Make sure that the main switch-breaker is open.
2) Make sure that the autopilot "AP MASTER" switch is set to "OFF".
3) Put the wrench Allen 3/32 in the orifice (3) of the front panel of the flight computer (2).
4) Loosen the locking device up to stop. Do not force it.
5) Remove the computer from its rack (1).
NOTE : The aircraft static circuit is open when the flight computer is removed from its rack. Install a blanking plug on the aircraft static circuit pipe connected to the flight computer if the aircraft must be used without it.
C. Installation of the flight computer (Figure 401)
1) If the aircraft static circuit pipe connected to the flight computer (2) is blanked, remove the blanking plug.
2) Make sure that the main switch-breaker is open.
3) Make sure that the autopilot "AP MASTER" switch is set to "OFF".
4) Lubricate with grease TB 04-900, the 0-ring of the static union located on the rear of the flight computer.
5) Check pins of the connectors attached at the bottom of the flight computer rack (1) for condition.
6) Install the flight computer in the rack.
7) Put the wrench Allen 3/32 in the orifice (3). Screw the locking device and check the equipment is in correct position.
8) If the flight computer has been replaced, refer to HONEYWELL Installation and Maintenance Manual, P/N 006-00776-0000 at Amendment D or above. Perform the maintenance procedure specified in Paragraph 6, section "KFC 225 maintenance matrix" relative to the removal of the KC 225 flight computer.
9) Test tightness of the static circuit — refer to 34-11-00.
10) Make sure all the tools and materials are removed and the work area is clean and free from debris.
11) If the flight computer has been replaced, perform a check flight.
WA
Validity : KFC 225 22-12-02 Page 401
(BA) JUN 04
 

  1 - Rack
2 - A82 flight computer
3 - Orifice
Variante de localisation Alternate location
 
A82 flight computer — Removal/Installation
Figure 401
WA
Validity : KFC 225 22-12 02Page 402
(BA) NOV 01
 
B36 ROLL SERVO ACTUATOR
REMOVAL / INSTALLATION
1. REMOVAL OF B36 ROLL SERVO ACTUATOR (Figure 401)
NOTE : The removal of B36 roll servo actuator does not require the removal of the mounting plate.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 22 AUTO FLIGHT TB20飛機維護手冊 22 自動飛行(45)