曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

A. Tool and consumable materials
- Immobilization tool P/N T700A2799000009
- Loctite (TB 08-935)
B. Procedure
1) Make sure the controls immobilization tool of the pilot's control wheel is in correct position.
2) Check cable assembly (16) for condition — refer to 20-00-07.
3) Install mounting plate (9) on support (3), and attach it with bolts (4), washers (10) and new nuts (11).
4) Screw turnbuckle barrel (19) onto threaded end (18) to ensure grip over two threads.
5) Put the drive capstan (8) with stud (20) housing directed upwards.
6) Wind up drive capstan (8) — refer to Detail C. Tighten the cable manually and make sure it is in correct position in the drive capstan grooves.
7) Connect cable assembly (16) to turnbuckle barrel (19) ensuring the same thread grip as for threaded end (18). Install immobilization tool (21) and screw the turnbuckle barrel until you slightly tighten the cable.
8) Remove the controls immobilization tool from pilot's control wheel.
9) Deflect the aileron control and check that the cable assembly (16) remains in correct position on drive capstan (8).
10) Check screw (5) and washer (6) for condition. Replace them if necessary.
CAUTION : WHEN INSTALLING GUARD (7), MAKE SURE THE LUGS ENGAGE CORRECTLY IN THEIR HOUSING. INCORRECT INSTALLATION CAN DAMAGE THE GUARD.
WA
Validity : KFC 225 KS 271C 22-12-03Page 402
(BA) JUN 04
 
11) Apply loctite TB 08-935 on screw (5) thread. Install guard (7), washer (6) and screw (5).
NOTE : The guard can be in various angular positions. Make sure it is not against the cable strands.
12) Install B36 roll servo actuator (12) — refer to Paragraph 2.
13) Adjust the tension of cable assembly (16) — refer to Page 501.
14) Make sure all the tools and materials are removed and the work area is clean and free from debris.
15) Install the cowling under hull 218F.
16) Close "AP CMPTR" and "AP SERVOS" circuit breakers.
17) Refer to HONEYWELL Installation and Maintenance Manual, P/N 006-00776-0000 at Amendment D or above. Perform the tests specified in Paragraph 6 section "KFC 225 MAINTENANCE MATRIX".
WA
Validity : KFC 225 KS 271C 22-12 03Page 403
(BA) JUN 04
 
1 - Washer
2 - Bolt
3 - Support
4 - Bolt
5 - Screw
6 - Washer
7 - Guard
8 - Drive capstan
9 - Mounting plate
10 - Washer
11 - Nut
12 - B36 roll servo actuator
13 - Connector
14 - Captive nut
15 - Screw
16 - Cable assembly
17 - Locking pin
18 - Threaded end
19 - Turnbuckle barrel
20 - Stud
21 - Immobilization tool
B36 roll servo actuator — Removal / Installation
Key to Figure 401
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 22 AUTO FLIGHT TB20飛機維護手冊 22 自動飛行(47)