F. Procedure (Fig. 401)
 S 144-021
 (1)  
Clean the surfaces for an electrical bond at the location of each bonding jumper (AMM 20-10-22/701).

 S 434-022

 (2)  
Remove the caps from the hydraulic lines and the ports of the hydraulic pump (28).

 S 644-023

 (3)  
Apply hydraulic lubricant or hydraulic fluid to the packings (5, 9, 12) and to the threads of the union (4) and the reducers (8, 11).

 S 434-024

 (4)  
Install the union (4), the reducers (8, 11) and the packings (5, 9, 12) in the ports of the hydraulic pump (28).

 S 034-025

 (5)  
ON AIRPLANES WITH VICKERS PUMPS;
 do these steps:

 (a)  Look at the plug which is in the seep port of the hydraulic pump (28) to identify the type of the plug. There are two types of plugs; a solid plug or a plug with vents.
 NOTE: The solid plug, P/N 73866, does not have vent holes.
____ You can identify the plug with vents by the two holes in the flat surfaces of the hexagonal area.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 29-11-01
 ALL  ú ú 03 Page 407 ú Sep 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 CAUTION: YOU MUST REMOVE THE SOLID PLUG, P/N 73866, FROM THE SEEP
_______ PORT OF THE PUMP. IF YOU DO NOT REMOVE THIS PLUG, THE PUMP CAN BECOME TOO HOT.
 (b)  If a solid plug, P/N 73866, is in the seep port of the hydraulic pump (28), remove the plug and the O-ring from the hydraulic pump (28).
 NOTE: If the plug has vent holes, you must not remove it
____
 from the hydraulic pump (28).

 S 434-054
 (6)  If necessary, install the vibration isolators (18) on the mounting plate (21).
 NOTE: All four vibration isolators must be the same part number.
____
 S 434-028
 (7)  
Install the washers (23) and the bolts (22) to attach the vibration isolators (18) to the mounting plate (21).

 S 434-055

 (8)  
Install hydraulic pump (28) on the vibration isolators (18).

 S 614-029

 (9)  
Fill the hydraulic pump (28) with hydraulic fluid.

 S 434-030

 (10)
 Install the supply hose (6) on the hydraulic pump (28).

 S 424-031

 (11)
 Put the hydraulic pump (28) in its position.

 NOTE:____The weight of the hydraulic pump (28) is 45 pounds. Make sure you hold the hydraulic pump (28) sufficiently while you install the fasteners.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 液壓 CHAPTER 29 - HYDRAULIC POWER 1(177)