C. No return from consignment inventory will be issued for any reason beyond 30 days from the ship date to the customer or designated shipping point.
D. All consignment returns will be treated the same as AMES Material Services, Inc. returns. The only exception is that the 'RMA' number is recorded in a separate logbook for consignment material only.
5. Scrapping Consignment Material
A. The Supervisor of AMES Material Services, Inc. must approve scrapping any material from consignment inventories.
B. Returned material from customer that has been deemed BER (beyond economical repair) by a FAA certified repair facility will be kept in a separate crate and shipped back to the consignor upon request or return of consignment.
C. Scrapping of consignment expendable parts must be approved by the Supervisor of AMES Material Services, Inc. and any major scrapping, such as seals or o-rings, will be pre-approved by inventory listing given to consignor.
D. These are the steps to take scrapped units out of the PMI from the consignment program. Please list the scrapped item(s) on a 'SMT' and the consignment name being scrapped. The 'SMT' will need to be kept on file for the year and consignment which unit being scrapped.
MEASURING AND TEST EQUIPMENT
1. General
A. AMES Material Services, Inc. does not require or use measuring and test equipment or calibrated tooling.
B. In the event that AMES Material Services, Inc. determines that measuring and test equipment or calibrated tooling is required by contract or for sample inspection, this policy will be revised to provide said requirement.
MATERIAL CONTROL
1. Handling and/or Transportation
A. This section describes the handling and/or transportation of all parts and materials to properly prevent damage. Components requiring extreme care or caution are described below for special attention in handling and/or transportation.
2. Electrostatic Discharge Sensitive Devices
A. Electrostatic Discharge Sensitive Devices (ESD)
NOTE: Electrostatic or static sensitive nomenclature is considered the same.
Electrostatic charges, (static electricity) referred to in this procedure, are generated and stored on plastic surfaces, garments, ungrounded human bodies, and other commonly unnoticed sources of static electricity. The passage of these charges through Electrostatic Discharge Sensitive Devices can result in component failure, major electrical characteristic change, or performance degradation.
(1)
All materials, parts, assemblies and sub-assemblies shall be handled and/or processed in a manner, which will prevent damage and/or deterioration.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AMES MATERIAL SERVICES, INC.PROCEDURES MANUAL(32)
