-
 altimeter;

-
 compass.

b)    Engine control instruments  
-fuel quantity indicator;
-oil pressure indicator;
-oil temperature indicator;
-tachometer;

-oil quantity indicator or oil dipstick -coolant temperature indicator (for engines cooled with fluid) -cylinder head temperature indicator
NOTE:
Since the ROTAX 912S engine uses mixed cooling (air and fluid) and the engine manufacturer recommends as necessary and sufficient the CHT measurement, a corresponding indicator was used, as per the manufacturer's requirements.
9.8. Control panel equipment
a)  Flight control
-Airspeed indicator;
-
 Altimeter;

-
 Magnetic compass;

-
 Vertical speed indicator - optional;

-Slip indicator;
- Clock - optional.
b) Engine control
-
 Tachometer;

-
 Oil temperature indicator;

-
 Oil pressure indicator;

-
 Cylinder head temperature indicator;

-
 Fuel quantity indicator;

-
 Ammeter;

-
 Voltmeter.

c) Warning lamps
 -Failure at generator unit;
 -
 Auxiliary pump operation;

 -
 Power network ON.

S.C. AEROSTAR  S.A.
FESTIVAL R40S
BACAU - ROMANIA
   AIRPLANE MAINTENANCE MANUAL
9.9. Maintenance of control panel instruments
Level of certification needed: Owner Remove the screws for fastening the panel on the airframe and pull the panel out as much as needed to ensure access to the inside.
Check the operation of the control panel instruments. 
Check the control panel condition. Verify the control panel fastening onto the fuselage.
Inspect the inside area of the control panel, paying special attention to the condition of the

flexible pipes of the anemo-barometric instruments. Check the condition and secure fastening of the aircraft instruments. Check the condition and secure fastening of the circuit breakers and switches on the control
panel. Remove any damages and replace any faulty items.
9.10. Maintenance of anemo-barometric instruments
Level of certification needed: A&P Mechanic
1. Checking the air tightness in the manifold pressure circuit
1.
Plug the portable pressure bench into the manifold intake.

2.
Apply a pressure able to move the airspeed indicator needle at 3 / 4 of its maximum travel.

3.
Set the pressure source to the above value.

4.
Monitor the air speed indicator for a minute. After a minute, the speed decrease should not exceed

6.25 mph.
5.
Gradually bring the circuit to normal pressure.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：FESTIVAL R 40S AIRPLANE MAINTENANCE MANUAL(45)