曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Both wheels are fitted with disk brakes, controlled separately, and hydraulically operated by means of the rudder pedals.
Usable wheel types (with the wheel shaft varying with the wheel types):
-main gears:   Matco W62 wheels, Mc Creary tires 15 x 6.00 – 6 and Mc Creary air tubes 15 x 6.00 – 6;
- nose gear: Matco wheel, Mc Creary tire 5.00-5-6ply and Mc Creary air tube 5.00-5;
Ground handling during aircraft running on airfield is achieved by steering the nose wheel by means of the rudder pedal, and via differentiated braking on each main wheel.
S.C. AEROSTAR  S.A.
FESTIVAL R40S
BACAU - ROMANIA
   AIRPLANE MAINTENANCE MANUAL
3.2.2. Maintenance of landing gear
Level of certification needed: A&P Mechanic
The landing gear maintenance consists in inspection, adjusting, cleaning and greasing.
The main landing gear inspection comprises the following checkups:
-general condition of the main landing gear blades and their fastening at the fuselage

(check for distortions, dents, loosened fastening on the fuselage); tighten any loose
elements; -general condition of the wheel axle, also checking its secure fastening at the main gear; -air pressure in the tires; -technical condition of the wheel hub, ball bearings and fasteners (check for damages);
replace any damaged fastener;
-technical condition of tires (check for wears beyond allowable limits, punctures, cuts all the way to the casing folds, rubber aging); whenever identifying the above-mentioned non-conformances or a depth decrease of the tire grooves below 0.08 inch, replace the tire;
-technical condition of the brake mechanism (check its integrity and secure fastening of the pipes and joints, check the brake fluid level inside the tank, check for any leakage throughout the system), check the good operating condition of the brake system for both pilots; if the friction plate wear in the clamps exceeds 0.06 inch., replace the brake shoes;
-technical condition and operation of the parking brake.
For the nose gear check the following:
-general technical condition of the gear and its fastening onto the fuselage (check for

distortions, cracks at the weld beam, loosened fastening onto the engine mount); tighten
any loosened elements; -technical condition of the rubber shock-absorbers (check for cracks and aging); -technical condition of nose wheel (procedure similar to the one applied for the main
wheel);
-technical condition of the control mechanism (check the integrity and secure fastening of the rods and joints throughout the system), check the operating condition of the gear-steering control system for both pilots.
To lubricate the ball bearings, use grease for U85Ca3 ball bearings, or equivalent. 
Replace all ball bearings exhibiting plays.
The shock-absorbers are replaced during overhauls, or 5 years after the year of manufacture.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：FESTIVAL R 40S AIRPLANE MAINTENANCE MANUAL(24)