%
Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003
37-00-00
AMM
% 4. Adjust the Vacuum Regulator
% WARNING: DO NOT USE METAL TOOLS THAT CAN TOUCH THE ELECTRICAL
% CONNECTIONS ON THE INSTRUMENT PANEL FLOOR. % %
%
%
%
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Remove the instrument panel cover. Refer to Section 25-10.
(2) Do an engine run-up. Refer to Section 71-01.
(3) Make a note of the vacuum value.
(4) If necessary, adjust the vacuum regulator: S Bend the lock-tabs away from the T-bar. S Turn the T-bar to adjust the vacuum. S Bend the lock-tabs to lock the T-bar. The vacuum must be 4.8 - 5.4 inHg at 1800 RPM. On the bottom of the regulator. Monitor the vacuum value.
(5) Shut down the engine.
(6) Install the instrument panel cover. Refer to Section 25-10.
%
Page 204 Doc # 6.02.01 09 Jan 2003 Rev. 4
37-00-00
Vacuum
AMM
% 5. Remove/Install the Suction Gauge
%
%
%
%
%
%
%
% A. Remove the Suction Gauge %
Detail Steps/Work Items Key Items/References
(1) Remove the instrument panel cover. Refer to Section 25-10.
(2) Release the flexible hose to the vacuum gauge. Refer to Figure 2. Put a cap on the hose end.
(3) Remove the bezel nut that attaches the gauge to the instrument panel.
(4) Remove the gauge from the instrument panel.
% % B. Install the Suction Gauge %
%
%
%
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Put the vacuum gauge in position in the instrument panel. Refer to Figure 2.
(2) Install the bezel nut that attaches the gauge.
(3) Connect the flexible hose to the vacuum gauge.
(4) Install the instrument panel cover. Refer to Section 25-10.
(5) Do an engine run-up. Refer to Section 71-01. Do a test for correct operation of the vacuum system. If necessary, adjust the system.
%
Doc # 6.02.01 Page 205
Rev. 4 09 Jan 2003
37-00-00
AMM
% Intentionally left blank
37-00-00
AMM
Structures
CHAPTER 51
STANDARD PRACTICES AND
STRUCTURES
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
51-TITLE
Structures
AMM
Intentionally left blank
51-TITLE
AMM
Structures
TABLE OF CONTENTS
CHAPTER 51
STANDARD PRACTICES AND STRUCTURE
1.
General ..............................................1
2.
Types of Structure ......................................2
3.
Laminated Components..................................2
4.
Sandwich Structure .....................................2
5.
Bonded Components ....................................3
6.
Repair Limitations ......................................3
Section 51-10
Investigation
1.
General ..............................................1
2.
Damage Classification ...................................1
3.
Types of Damage ......................................2
4.
Inspection Techniques ...................................2
5.
Further Inspection ......................................3
中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 4(26)
