Figure 11-1. Exterior Placards and Markings 
11-20-00 
Page 11-5 
Revised: February 28, 2002 
1E15 

THIS PAGE INTENTIONALLY BLANK

11-20-00 Page 11-6 Revised: February 28, 2002
1E16
INTERIOR PLACARDS AND MARKINGS.

1.
PLACARD - HYDRAULIC FLUID SPEC 13. PLACARD - WARNING

2.
PLACARD - SOFT WEAR 14. MEDALLION - PIPER, CONTROL WHEEL

3.
PLACARD - BAGGAGE LIMITATIONS 15. PLACARD - CABIN AIR

4.
PLACARD - FUEL SELECTOR 16. PLACARD - DOME LIGHT MAXIMUM

5.
PLACARD - STABILATOR TRIM 17. PLACARD - STORM WINDOW

6.
PLACARD - FLAP LEVER 18. PLACARD - OPERATING LIMITATIONS

7.
PLACARD - DOOR LOCK 19. PLACARD - STROBE LIGHT WARNING

8.
PLACARD - DOOR RELEASE 20. PLACARD - WARNING

9.
PLACARD - EMERGENCY EXIT DOOR 21. PLACARD - PRIMER

10.
PLACARD - OPEN 22. PLACARD - STARTER ON

11.
PLACARD - LATCH 23. PLACARD - A/P INTR. (OPTIONAL)

12.
PLACARD - MIKE 24. PLACARD - TRANSPONDER IDENTIFIER

Figure 11-2. Interior Placards and Markings (Sheet 1 of 2)
11-30-00 Page 11-7 Revised: February 28, 2002
1E17

11-30-00 Page 11-8 Revised: February 28, 2002
1E18
Meyercord Decals, manufacturered by Mark-It, 1055 Paramount Tarkway, Batavia. IL 60510, may be installed on the instrument panel. The following procedures should be followed in the event one or more of these decals must be replaced.
(1)  Removal of Meyercord Decals
— CAUTION —
DO NOT USE LACQUER THINNER ON ANY PANEL THAT HAS BEEN
PAINTED WITH ENAMEL OR LACQUER. FACTORY PANELS ARE
PAINTED WITH POLYURETHANE PAINTS.

(a)  Remove placard to be replaced with of clean cloth dampened with lacquer thinner.
— CAUTION —
MARK-IT J-70 SOLVENT WILL REMOVE ENAMEL, LACQUER, AND
POLYUTHERANE BASED PAINT PRODUCTS IF LIQUID IS DROPPED
ONTO PAINTED AND NOT REMOVED IMMEDIATELY.

(b)  If panel is painted with enamel or lacquer use a clean cloth dampened with Mark-It J-70 solvent to remove placard to be replaced.
(2)  Installation of Meyercord Decals
(a)  
Mix a solution consisting of 2 parts water and 1 part J-70 solvent (P/N 179-497).

(b)  
Prepare surface to receive decal by wiping it with a clean cloth dampened with the diluted J-70 sovlent prepared above.

(c)  
Submerge decal in the mixed J-70 solution for approximately 3 to 5 seconds.

(d)  
Remove decal from mixed solution and lay in position

(e)  
Using a rubber squeegee, squeegee from center to edges to remove excess solution.

(f)  
Wait approximately 1 to 1 1/2 minutes, then remove backing paper.

(g)  
Using a damp sponge, remove excess solution from face of decal and surrounding area.

11-30-00 Page 11-9 Revised: February 28, 2002
GRIDS 1E20 THRU 1E24
INTENTIONALLY BLANK

11-30-00 Page 11-10 Revised: February 28, 2002
1E20

CHAPTER

12

SERVICING

THIS PAGE INTENTIONALLY BLANK

CHAPTER 12 - SERVICING
TABLE OF CONTENTS / EFFECTIVITY

CHAPTER/ GRID SECTION SUBJECT NO. EFFECTIVITY
12-00-00 GENERAL 1F5 1R0202
Engine Cleaning 1F5 1R0202
Aircraft Finish Care 1F5 A0202 Dupont Imron 6000 Paint System 1F5 A0202 Cleaning Exterior Surfaces 1F6 1R0202
Cleaning 1F7 Windshield and Windows 1F7 1R0202 Headliner, Side Panels and Seats 1F7 1R0202 Carpets 1F7 Landing Gear 1F7 1R0202
12-10-00 REPLENISHING 1F9
Fuel System 1F9 Filling Fuel Tanks 1F10 Draining Moisture From Fuel System 1F10 Draining Fuel System 1F10
Oil System 1F10 Draining Oil Sump 1F11 Filling Oil Sump 1F11 Oil Screen (Suction) 1F11 Recommendations for Changing Oil 1F11 Oil Filter (Full Flow) 1F12
12-20-00 SCHEDULED SERVICING 1F13
Landing Gear 1F13 Servicing Oleo Struts 1F13 Filling Nose Gear Oleo Strut 1F13 Filling Main Gear Oleo Struts 1F14 Inflating Oleo Struts 1F15 Servicing Steering Bungees 1F15
Brake System 1F16 Filling Brake Cylinder Reservoir 1F16 Draining Brake System 1F16
12-Cont./Effec. Page 12-3 Revised: February 28, 2002
CHAPTER 12 - SERVICING 
TABLE OF CONTENTS / EFFECTIVITY 
CHAPTER/ SECTION  SUBJECT  GRID NO.  EFFECTIVITY 
12-20-00  SCHEDULED SERVICING (CONT) 
Tires Tire Balance  1F16 1F16 
Hydraulic System Hydraulic Pump/Reservoir  1F17 1F17 
Battery  1F17 
Induction Air Filter Removal of Air Filter Service Instructions (Inspection and Replacement) Installation of Air Filter  1F18 1F18 1F18 1F18 
Alternate Air Heat Door  1F18 
Lubrication Instructions Application of Oil Application of Grease  1F19 1F19 1F20  1R0202 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：西門諾爾飛機維護手冊 simenole PA-44-180 AMM 1(25)