(2)  
When the GYRO warning flag retracts from view, pull the cage knob and hold it.

 S 865-005

 (3)  
After the indicator becomes stable at the zero pitch and the zero roll position, release the knob quickly.

 NOTE: Do not let the cage knob hit against the indicator front.
____
 S 715-006
 (4)  
After 6 minutes, make sure the pitch and roll show | 1.0 degree of airplane attitude.

 S 715-007

 (5)  
Open the STBY INSTR ATTD IND circuit breaker and make sure the GYRO warning flag comes into view.

 S 715-008

 (6)  
Close the STBY INSTR ATTD IND circuit breaker and make sure the GYRO warning flag retracts from view.

 F. Test Of The Standby ILS Display Function
 S 865-009
 (1)  
Operate the central maintenance computer (CMC) from the left CDU (AMM 45-10-00/501).

 S 865-010

 (2)  
Tune to an ILS frequency (Ref 34-31-00/501).

 S 865-011

 (3)  
Set the mode selector switch on the standby attitude/ILS indicator to APP.

 S 745-012

 (4)
Do a left ILS receiver ground test from the CDU (Ref 34-31-00/501).

 (a)  Look at the standby attitude/ILS indicator and make sure that these indications occur: 1) The G/P and LAT flags are in view for approximately 3
 seconds.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-24-00
 ALL  ú ú 01 Page 502 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 2)  The G/P and LAT flags retract from view for approximately 2 seconds.
 3)  The lateral deviation bar moves to 1 mark to the left side of the center for approximately 3 seconds. At the same time, the vertical (glide path) deviation bar moves to 1 mark above the center.
 4) The deviation bars move to 1 mark down and 1 mark to the right side of the center until the end of the test. 5) Make sure that the CDU shows PASS.
 S 865-013
 (5)  
Set the mode selector switch to B/CRS.

 S 745-014

 (6)  
Do a left ILS receiver ground test from the CDU (Ref 34-31-00/501).

 (a)  Look at the standby attitude/ILS indicator and make sure that these indications occur: 1) The G/P and LAT flags are in view for approximately 3
 seconds.
 2)  The G/P and LAT flags retract from view for approximately 2 seconds.
 3)  The lateral deviation bar moves to 1 mark to the right side of the center for approximately 3 seconds. At the same time, the vertical (glide path) deviation bar moves to 1 mark above the center.
 4)  The deviation bars move to 1 mark down and 1 mark to the left side of the center until the end of the test. 5) Make sure that the CDU shows PASS.
 S 865-015
 (7)  Set the mode selector switch to OFF and make sure that these indications occur:
 (a)  
The G/P and the LAT flags are out of view.

 (b)  
The vertical and lateral deviation bars retract from view.

 S 865-016
 (8)  Remove the electrical power if it is not necessary
 (Ref 24-22-00/201).

 TASK 34-24-00-735-017
 3.  System Test - Standby Attitude Reference System_______________________________________________
 A.  Standard Tools and Equipment
 (1) VOR/ILS ramp test set - Instrument Flight Research Type NAV-401L
 B.  References
 (1)  
24-22-00/201, Electrical Power - Control

 (2)  
34-31-00/501, ILS Navigation System

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-24-00
 ALL  ú ú 01 Page 503 ú Jun 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 C. Access
 (1)  Location Zones
 221 Control Cabin, LH

 D. Prepare for the test.
 S 865-018
 (1)  
Supply the electrical power (Ref 24-22-00/201).

 S 865-019
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 2(15)