(b)
Set the mode selector switch on the WXR control panel to the TEST position.
NOTE:____Read through these messages before you do the test. If necessary, you can do the test more than once to do a check of the messages.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-43-00
ALL ú ú 11 Page 503 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(c)
(d)
(e)
(f)
(g)
A
747-400 MAINTENANCE MANUAL
Make sure this PWS test sequence occurs in 0-2 seconds
(Fig. 501):
1) The Amber WINDSHEAR message on the NDs is off.
2) The WINDSHEAR SYS (Advisory) message on the upper EICAS
display comes on. 3) The WINDSHEAR PRED (Status) message on the lower EICAS
display comes on. 4) The Aural Warning message is MONITOR RADAR DISPLAY. 5) A WXR test pattern is shown on both NDs.Make sure these indications occur in 2 to 12 seconds (Fig 501): 1) The Amber WINDSHEAR message on the NDs stays off. 2) The RED WINDSHEAR messages on the captains and first
officers NDs and PFDs comes on. 3) A WINDSHEAR SYS (Advisory) message is on the upper EICAS display goes off. 4) The WINDSHEAR PRED (Status) message on the lower EICAS display goes off. 5) The captains and first officers master warning lights come on.
6) The aural message on the captain's and first officer's loudspeaker is one of the two messages below: a) Go Around-Windshear Ahead, (pause) Windshear Ahead,
Windhshear Ahead.
b) WINDSHEAR AHEAD, WINDSHEAR AHEAD. 7) A WXR test pattern shown on the NDs. 8) A 0 degrees tilt code message is on the captains and first
officers NDs.When the test is complete, make sure that the WXR TEST message is on the NDs.Make sure the test displays on the NDs are as follows (See Fig. 501): 1) The tilt message on the ND will read 0 degrees. 2) A WXR TEST pass message shows. 3) The half range message shows in the center.
NOTE: No gain message will be shown in the test mode.
____
4) The range marks have equal space between them. 5) When the test pattern has completed the scan on the NDs,
the self test is completed.Make sure the test pattern on each ND is as follows: 1) A green color band is at the bottom of the test pattern 2) A yellow color band is above the green band 3) A red color band is above the yellow band
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-43-00
ALL ú ú 09 Page 504 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(h)
(i)
(j)
(k)
(l)
(m)
(n)
A
747-400 MAINTENANCE MANUAL
4) A magenta wedge is in the center.If external failures occur, an antenna tilt fault code message will show in place of the antenna tilt message on the NDs (See Fig. 502). 1) The tilt code messages on Fig. 502 identify which external
LRU or condition is faulty. 2) Refer to the weather radar BITE procedures in the fault
isolation manual (FIM).If WXR radar failures occur a WXR message and a WXR LRU message will be shown on the NDs. 1) Refer to the weather radar BITE procedures in the FIM.Set the WX RADAR switch on the WXR control panel to the SYS R position.Make sure the PWS test sequence occurs in 0-2 seconds (Fig. 501): 1) The Amber WINDSHEAR message on the NDs is off. 2) The WINDSHEAR SYS (Advisory) message on the upper EICAS
display comes on. 3) The WINDSHEAR PRED (Status) message on the lower EICAS
display comes on. 4) The Aural Warning message is MONITOR RADAR DISPLAY. 5) A WXR test pattern is shown on both NDs.Make sure these indications occur in 2 to 12 seconds (Fig 501): 1) The Amber WINDSHEAR message on the NDs stays off. 2) The RED WINDSHEAR messages on the captains and first
officers NDs and PFDs comes on. 3) A WINDSHEAR SYS (Advisory) message is on the upper EICAS display goes off. 4) The WINDSHEAR PRED (Status) message on the lower EICAS display goes off. 5) The captains and first officers master warning lights come on.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 2(109)
