24-23-03
 ALL  ú ú 01 Page 402 ú Jun 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 024-017
 (4)  
Remove the transformer:

 (a)  
Remove the four screws that attach the transformer to the panel.

 (b)  
Remove the transformer from the panel.

 TASK 24-23-03-404-003
 3. Generator Control Current Transformer Installation (Fig. 401)
__________________________________________________
 A. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 45-10-00/201, Central Maintenance Computer System

 (3)  
AIPC 24-23-03-01, AIPC 24-23-03-02, AIPC 24-23-03-03, AIPC 24-23-03-04

 (4)  
WDM 24-21-12, WDM 24-21-22, WDM 24-21-32, WDM 24-21-42

 (5)  
SSM 24-21-01, SSM 24-21-02, SSM 24-21-03, SSM 24-21-04

 B.
Access

 (1)  
Location Zone
 117 Electrical and Electronics Compartment, LH
 118 Electrical and Electronics Compartment, RH

 (2)  
Access Panel
 P514 Generator 1 Power Center - Left
 P614 Generator 2 Power Center - Left
 P515 Generator 3 Power Center - Right
 P615 Generator 4 Power Center - Right

 C.
Install the Generator Control Current Transformer

 S 424-004
 (1)  
Install the transformer:

 (a)  
Put the transformer in its position in the applicable panel.

 (b)  
Install the four screws that attach the transformer to the panel.

 (c)  
Tighten the screws.

 (d)  
Connect the applicable electrical connector to the transformer. ~....................................... | Equipment Number | ......................................... | Unit | Connector | Panel | ......................................... | T4004 | DT4004 | P514 | | T4005 | DT4005 | P614 | | T4006 | DT4006 | P515 | | T4007 | DT4007 | P615 | 2............….............…............1

 (e)  
Close the access door for the panel.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 24-23-03
 ALL  ú ú 01 Page 403 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 D. Do a Test of the Generator Control Current Transformer
 S 864-005
 (1)  
Supply electrical power to the main AC buses with external or APU generator power (Ref 24-22-00/201).

 S 864-006

 (2)  
Set the UTILITY-L and UTILITY-R switches, on the P5 panel, to the latched position.

 S 864-007

 (3)  
Set the GEN CONT switches, on the P5 panel, to the latched position.

 S 864-008

 (4)  
Start two engines (AMM 71-00-00/201).

 NOTE: The two engines that you start must be on opposite sides of
____ the airplane. One of the engines must drive the Integrated Drive Generator (IDG) related to the current transformer being tested. Use the table that follows to find the proper IDG.
 ~....................................... | Unit | IDG | Engine | ......................................... | T4004 | IDG-1 | 1 | | T4005 | IDG-2 | 2 | | T4006 | IDG-3 | 3 | | T4007 | IDG-4 | 4 | 2............….............…............1
 S 714-009
 (5)  
Make sure the "OFF" lights on the GEN CONT switches on the P5 panel go off once the engines reach idle speed.

 S 714-010

 (6)
Make sure the "OPEN" light on the SPLIT SYSTEM BREAKER switch is off. The SPLIT SYSTEM BREAKER switch is on the P461 panel.

 (7)
Get access to the electrical maintenance page (AMM 45-10-00/201).

 S 714-012

 (8)  
Make sure the lower EICAS display shows the display that follows: 110 to 120 AC-V FREQ is 395 to 405 Hz LOAD for both generators are within .05 of each other.

 (9)  
Stop the engines (AMM 71-00-00/201).

 S 014-011
 S 844-013
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 ELECTRICAL POWER 電源 2(23)