S 434-013-B00

 (9)  
Connect the wires for the emergency exit light to the light assembly.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 53-51-21
 ALL  ú ú B01 Page 404 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 764-024-B00
 (10) Measure the electrical bonding resistance between the conductive fasteners and the conductive surface of the fairing panel.
 (a) Make sure the maximum resistance does not exceed 0.5 OHMs.
 NOTE: Make the resistance measurement prior to painting
____ the panel and the mounting hardware. If the fairing panels and bolts have been covered with paint, you may not get a correct reading. In this case, use two sharp probes and make sure the probes contact the conductive surface on the panel and the structure then measure the resistance.
 S 864-014-B00
 (11) Close these circuit breakers on the P18 circuit breaker panel and remove the DO-NOT-CLOSE tags.
 (a)
Automatic Direction Finder AC.

 (b)
Automatic Direction Finder DC.

 (c)
Overwing emergency exit light.

 S 434-015-B00
 (12)
 Install the ADF sense antenna coupler (Ref 34-57-21/401).

 S 714-016-B00

 (13)
 Do a check of the emergency exit light to make sure it is serviceable (AMM 33-51-22/201).

 (14)
 Do an operational check of the ADF system (AMM 34-57-01/501).

 (15)
 Return the airplane to it's original condition.

 S 714-017-B00
 S 864-025-B00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 53-51-21
 ALL  ú ú B03 Page 405 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 NOSE RADOME - DESCRIPTION AND OPERATION
_______________________________________
 1.  General_______
 A.  The nose radome extends forward from body station 178. The two main functions of the radome are to serve as a fairing and to house the weather radar antenna and the glide slope antenna director bar.
 B.  The radome is a cone-shaped structure of fiberglass and is hinged at two places to the top side of the bulkhead at body station 178. Further attachment of the radome is by fasteners which screw into clips on the bulkhead at body station 178. In the open position, the radome is supported by rods.
 C.  The weather radar antenna is cantilevered from the bulkhead at body station 178.
 D.  The nose of the radome is equipped with erosion protection. The radome is provided with lightning diverter strips on the exterior surface.
 E.  The glide slope antenna director bar is a passive element of the glide slope antenna used to alter the glide slope radiation antenna patterns such that the navigation units have maximum glide slope sensitivity. The bar consists of a 13-inch strip of pressure-sensitive aluminum foil tape installed horizontally inside the nose radome approximately 22 inches forward of the aft edge of the nose radome top centerline.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 53-52-00
 ALL  ú ú B01 Page 1 ú Nov 15/87
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 NOSE RADOME - REMOVAL/INSTALLATION
__________________________________
 1. General
_______
 A. This section contains two tasks:
 (1)  
The removal of the nose radome.

 (2)  
The installation of the nose radome.

 TASK 53-52-00-004-001-B00
 2. Nose Radome Removal (Fig. 401)
___________________
 A. References
 (1)  34-41-11/401, Weather Radar Antenna
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 機身 FUSELAGE(24)