曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 when the left thrust lever is at 32 |1°.
 S 085-022
 (7)  Remove the protractor and adapter from the left thrust lever.
 S 485-025
 (8)  Attach the protractor and adapter to the right thrust lever.
 S 725-023
 (9)  Do these steps to see that the module gets the correct input from
 the right throttle switch:
 (a) Move the thrust levers to the idle stop.
 (b) Make sure that the WING ANTI-ICE switch is in the ON position.
 (c) Slowly push the right thrust lever forward.
 (d) Make sure that the L VALVE OPEN and R VALVE OPEN lights come on
 bright when the right thrust lever is at 32 |1°.
 (e) Move the right thrust lever forward to its stop.
 (f) Slowly move the right thrust lever aft.
 (g) Make sure the L VALVE OPEN and R VALVE OPEN lights become dim
 when the right thrust lever is at 32 |1°.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 30-11-41
 ALL  ú ú 02 Page 503 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 085-024
 (10)
 Remove the protractor and adapter from the right thrust lever.

 S 865-017

 (11)
 Open the LANDING GEAR AIR/GND RELAY & LIGHTS circuit breaker on the P6 panel.

 S 725-018

 (12)
 Do these steps to make sure that the throttle switch inputs operate correctly in the air mode:

 (a)  
See that the WING ANTI-ICE switch goes to the off position automatically.

 (b)  
See that the L VALVE OPEN and R VALVE OPEN lights come on brightly and then go off.

 (c)  
Push the left throttle lever to the full power position.

 (d)  
Put the WING ANTI-ICE switch in the on position.

 (e)  
Make sure the L VALVE OPEN and R VALVE OPEN lights come on brightly for 1 to 3 seconds.

 (f)  
Make sure the L VALVE OPEN and R VALVE OPEN lights are on dimly after 3 seconds.

 (g)  
Pull the left throttle lever to IDLE.

 (h)  
Put the WING ANTI-ICE switch in the off position.

 (i)  
See that the L VALVE OPEN and R VALVE OPEN lights come on brightly and then go off.

 (j)  
Push the right throttle lever to the full power position.

 (k)  
Put the WING ANTI-ICE switch in the on position.

 (l)  
Make sure that the L VALVE OPEN and R VALVE OPEN lights come on brightly for 1 to 3 seconds.

 (m)  
Make sure that the L VALVE OPEN and R VALVE OPEN lights are on dimly after 3 seconds.

 (n)  
Pull the right engine throttle lever to IDLE.

 (o)  
Put the WING ANTI-ICE switch in the off position.

 (p)  
Make sure that the L VALVE OPEN and R VALVE OPEN lights come on brightly and then go off.

 

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 30-11-41
 ALL  ú ú 03 Page 504 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-019
 (13) Close the LANDING GEAR AIR/GND RELAY & LIGHTS circuit breaker on the P6 panel.
 F. Put the Airplane Back to Its Usual Condition
 S 865-011
 (1)  Remove electrical power if it is not necessary (Ref 24-22-00/201).
 TASK 30-11-41-705-027
 3.  Do a Check of the Thermal Switch Circuits to the Wing Anti-Ice Control Module_____________________________________________________________________________
 A. General
 (1)  This task will make sure that the inputs from the thermal switches casue the module to operate correctly.
 B. Standard Tools and Equipment
 (1)  Multimeter
 C. References
 (1)  
24-22-00/201, Manual Control

 (2)  
IPC 30-10-00

 (3)  
SSM 30-11-00

 (4)  
WDM 30-12-01

 D. Access
 (1)  
Location Zone 101 Control Cabin - Left 102 Control Cabin - Right 302 Left Wing Outboard Leading Edge Including Slats 402 Right Wing Outboard Leading Edge Including Slats 507 Strut 607 Strut
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 防冰和排雨(28)