(Continued
CENTER TANK BOOST PUMP LEFT and CENTER TANK BOOST
next page)
PUMP RIGHT circuit breakers for center fuel tank.
538 
28-22-0  Sep 01/02 
Page 108 
B
O
E
I
NG
P
R
OP
R
I
E
T
A
R
Y
 - Copyri
ght
 . - Unpubl
i
s
hed
W
o
r
k
 -
S
ee
t
i
t
l
e page f
o
r de
t
a
i
l
s
.
 

Fuel feed system operable. PROCEDURE 17 PROCEDURE 2 PROCEDURE 3 PROCEDURE 4 PROCEDURE 6
5C1 
Jun 20/83  28-22-0 
Page 109 
B
O
E
I
NG
P
R
OP
R
I
E
T
A
R
Y
 - Copyri
ght
 . - Unpubl
i
s
hed
W
o
r
k
 -
S
ee
t
i
t
l
e page f
o
r de
t
a
i
l
s
.
 

501 
28-22-0 Page 110  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Oct 20/84 

538 
Jan 20/83  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  28-22-0 Page 111 

538 
28-22-0 Page 112  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Nov 15/78 

538 
Sep 01/02  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  28-22-0 Page 113 

BOOST PUMP 115 V AC CIRCUIT BREAKER IS OPEN - Visually inspect each end of the conduit to make sure that the Teflon sleeves are visible and there is no fuel leak into the conduit. IF -

If installed, remove and examine the boost pump conduit wire
NOT OK
bundle (AMM 28-22-00/601). Repair any problems that you find.

Do not reconnect the electrical connector. Close the circuit breaker for the applicable pump. Put the applicable pump switch to the ON position. Wait five minutes. Put the applicable pump switch to the OFF position. The circuit breaker should remain closed. IF -
115 V AC CIRCUIT BREAKER OPENS WITH PUMP
NOT OK
DISCONNECTED - PROCEDURE 7

OK

Make sure the LOW PRESSURE lights for the center tank are off.
Make sure the LOW PRESSURE lights for the No. 1 and No. 2 tanks are on.

*[1]  To operate any of the fuel boost pumps, you must be in the flight compartment to continuously monitor the fuel quantity and the low pressure indication in the fuel tank.  Immediately put the applicable fuel boost pump switch(es) to OFF if the LOW PRESSURE light comes on and stays on.
28-22-0 May 01/03 Page 114 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.

PROCEDURE 7

Reconnect the boost pump electrical connector. Make sure there is sufficient fuel in the tank (see the General section). Put the applicable pump switch to the ON position for five minutes. *[1] The circuit breaker should remain closed. The low pressure light should not come on and stay on. Put the applicable pump switch to OFF.
*[1]  To operate any of the fuel boost pumps, you must be in the flight compartment to continuously monitor the fuel quantity and the low pressure indication in the fuel tank. Immediately put the applicable fuel boost pump switch(es) to OFF if the LOW PRESSURE light comes on and stays on.
500 
May 01/03  28-22-0 
Page 115 
B
O
E
I
NG
P
R
OP
R
I
E
T
A
R
Y
 - Copyri
ght
 . - Unpubl
i
s
hed
W
o
r
k
 -
S
ee
t
i
t
l
e page f
o
r de
t
a
i
l
s
.
 

5. Restore Airplanes to Normal
A. Remove leading edge flap locks (Ref 27-81-0 MP).
WARNING: LEADING EDGE FLAPS ARE FAST ACTING AND CAN CAUSE SERIOUS INJURY TO PERSONNEL.
B. Remove electrical power if no longer required.
500 
28-22-0 Page 116  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  May 01/01 

ENGINE FUEL FEED SYSTEM -MAINTENANCE PRACTICES
1.  
Two procedures, an engine performance deterioration (engine run) test and a vacuum test, are provided to check the engine fuel feed lines and fittings. The engine performance test requires specific fuel quantities, but no special equipment. The vacuum test requires special test equipment and empty fuel tanks.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 燃油 FUEL(106)