- do a check and repair the wiring from the indicator light (3WN2) to the SDAC-1(2) (1WV1(2)) pin K to pin AA (AD)/12B(12H) (Ref. ASM 52-73/01).
2 If there is no ground signal:
_
- repair the wiring from the connector (7WN2-A) pin A/C to the ground terminal (Ref. ASM 52-73/01).
(e) If the fault continues:
- do a check and repair the wiring from the indicator light (3WN2) to the indicator light (2WN2) pin A to pin B (Ref. ASM 52-73/01) and (Ref. ASM 52-73/01).
- do a check and repair the wiring from the indicator light (2WN2) to the indicator light (1WN2) pin A to pin B (Ref. ASM 52-73/01).
- do a check and repair the wiring from the indicator light (1WN2) to the relay (12WN) pin A to pin A/A2 (Ref. ASM 52-73/01).
- do a check and repair the wiring from the relay (12WN) to the circuit breaker (13WN) pin A/A3 to pin 2 (Ref. ASM 52-73/01).
- do a check and repair the wiring from the relay (12WN) to the circuit breaker (15WN) pin A/A1 to pin 2 (Ref. ASM 52-73/01).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-13-00∞∞∞∞∞∞∞∞∞∞Page 223
Nov 01/03R CES
(2) If the test does not confirm the fault:
- remove the jumper wire between the pins B and C of the connector (7WN2-A)
- connect the connector of the handle proximity switch (7WN2)
- adjust the handle proximity switch (7WN2) with the doors checking tool (Ref. AMM TASK 52-71-00-820-002) or with the ECAM system (Ref. AMM TASK 52-71-00-820-002).
(a) If the fault continues:
- replace the PROX SW-HANDLE, R AFT ESC SLIDE (7WN2) (Ref. AMM TASK 52-73-11-000-002) and (Ref. AMM TASK 52-73-11-400-002).
B. Test
(1) On the ECAM control panel:
- push the DOOR key to get the DOOR/OXY page.
(2) Make sure that the SLIDE indication is shown on the DOOR/OXY page when the R aft escape-slide handle is in the SLIDE ARMED position.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
(1) On the ECAM control panel, set the LOWER DISPLAY and the UPPER DISPLAY potentiometers to OFF.
(2) De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-13-00∞∞∞∞∞∞∞∞∞∞Page 224
Nov 01/03R
CES
TASK 52-13-00-810-806
No SLIDE Indication on the DOOR/OXY Page when the L Aft Escape Slide Handle is
in the SLIDE ARMED Position
1. Possible Causes
_______________
- IND LT-SLIDE ARMED, AFT L DOOR (3WN1)
- IND LT-SLIDE ARMED, L EMER EXIT (2WN1)
- IND LT-SLIDE ARMED, FWD L DOOR (1WN1)
- PROX SW-HANDLE, L AFT ESC SLIDE (7WN1)
- RELAY-PWR SPLY SWITCHOVER (12WN)
- wiring from the connector (7WN1-A) to the indicator light (3WN1)
- wiring from the indicator light (3WN1) to the SDAC-1(2) (1WV1(2))
- wiring from the connector (7WN1-A) pin A/C to the ground terminal
- wiring from the indicator light (3WN1) to the indicator light (2WN1)
- wiring from the indicator light (2WN1) to the indicator light (1WN2)
- wiring from the indicator light (1WN1) to the relay (12WN)
- wiring from the relay (12WN) to the circuit breaker (13WN)
- wiring from the relay (12WN) to the circuit breaker (15WN)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power AMM 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power AMM 31-60-00-860-001 EIS Start Procedure AMM 52-71-00-820-002 Adjustment of the Proximity Switches (4WN1, 4WN2,
7WN1, 7WN2, 13WV1, 13WV2, 17WV1, 17WV2) of the Passenger/Crew Doors with the CHECKING TOOL-DOORS
AMM 52-71-00-820-002 Adjustment of the Proximity Switches (4WN1, 4WN2, 7WN1, 7WN2, 13WV1, 13WV2, 17WV1, 17WV2) of the Passenger/Crew Doors with the ECAM DU.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 艙門 DOORS(53)
