_______________

 2. Job Set-up Information

______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
AMM  23-73-00-740-005 BITE Test of the Cabin Intercommunication Data System (CIDS) through the CFDS AMM 33-51-00-710-001 Operational Test of Emergency Lights by 'TEST EMER LIGHT SYS' Pushbutton
 3. Fault Confirmation
__________________
 A. Do the Test
 (1) Do the BITE test of the Cabin Intercommunication Data System (CIDS) (Ref. AMM TASK 23-73-00-740-005).

 (2) Do the CIDS1/DEU-B test through the CFDS.

 (3) Do the CIDS1/CIDS BUS test through the CFDS.

 (4) Do the operational test of the emergency lighting system (Ref. AMM TASK 33-51-00-710-001).

 4. Fault Isolation
_______________
R
R A. If the test gives a maintenance message, do the trouble shooting
R  procedure related to the maintenance message. NOTE : After the fault confirmation in above sequence and the fault
____ isolation with the related removal of the failure you will not see the PTP-messages NO EPSU DATA and NO COMMUNICATION again.

 TASK 33-51-00-810-819

 Emer. Lighting - The Exit Signs Flicker
 1. Possible Causes
_______________
 - RELAY 8WL

 - DIODE (on diode holder 1158VD)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
AMM  33-51-00-710-001 Operational Test of Emergency Lights by 'TEST EMER LIGHT SYS' Pushbutton ASM 33-51/00
 3. Fault Confirmation
__________________
 A. Do this Test
 (1) Do the operational test of the emergency lights by TEST EMER LIGHT SYS pushbutton (Ref. AMM TASK 33-51-00-710-001).

 (2) On the overhead panel 25VU, set the NO SMOKING switch 190RH to the ON position.

 (3) Monitor the EXIT signs in the cabin.

 (4) On the overhead panel 25VU, set the NO SMOKING switch 190RH to the AUTO position.

 (5) Monitor the EXIT signs in the cabin.

 4. Fault Isolation
_______________
 A. If the exit signs in the cabin flicker with the NO SMOKING switch 190RH in either the ON or the AUTO position:
 - replace the RELAY 8WL in the relay box 103VU in the electronics compartment (Ref. ASM 33-51/00).
 (1) If the fault continues:
 - replace the DIODE (on diode holder 1158VD) between pins 31 and 32 on panel 103VU126 (Ref. ASM 33-51/00).
 B. Do the test given in para. 3.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : ALL ∞∞33-51-00∞∞∞∞∞∞∞∞∞∞Page A205
 May 01/05 CES

 5. Close-up
________
 A. Put the aircraft back to its initial configuration.

R **ON A/C 106-149, 301-399, 401-499,
 TASK 33-51-00-810-820
 Difference between System Test Requirements and Switch Position - EPSU 10WL
 1. Possible Causes
_______________
 - EMER EXIT LT switch 4WL

 - wiring

 - EMER pushbutton switch

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
AMM 33-51-00-710-010 Operational Test of the Emergency Lights via MCDU ASM 33-51/01
 3. Fault Confirmation
__________________
 A. Do the operational test of the emergency lights via MCDU (Ref. AMM TASK 33-51-00-710-010).
 4. Fault Isolation
_______________
 A. If the test gives a different maintenance message, do the trouble shooting procedure related to the maintenance message.
 B. If the operational test gives the maintenance message:
 (1) EMER EXIT LT SW/FAP PB/EPSU(10WL)FWD L:
 (a) Make sure that on the panel 25VU:
 - the EMER EXIT LT switch 4WL is in the OFF position,

 - the EMER EXIT LT OFF light 5WL is on. 1 If the fault continues:

_

 - replace the EMER EXIT LT switch 4WL. 2 If the fault continues:

_
 - check and repair the wiring between: EPSU 10WL pin -D and EMER EXIT LT switch 4WL pin 3C, EPSU 10WL pin A and EMER EXIT LT switch 4WL pin 3B, EPSU 10WL pin B and EMER EXIT LT switch 4WL pin 2B (Ref. ASM 33-51/01).
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊(cè) LIGHTS 燈光(121)