A. If the test gives: -the message HYD Y ENG 2 PUMP LO PR on the upper ECAM DU, -the LO flag of the Yellow hydraulic system on the HYD page of the lower ECAM DU, -the PTU running indication on the HYD page of the lower ECAM DU,
NOTE : The PRESS SW-Y PUMP, ENG 2 (3074GD) sends a low pressure signal to
____ the ECAM system. This causes the PTU running indication on the lower ECAM DU, although the PTU does not operate (non system failure).
-the Yellow ENG 2 PUMP P/BSW FAULT light on panel 40VU:
- look on the HYD page of the lower ECAM DU and do a check of the pressure of the Yellow system.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞29-13-00∞∞∞∞∞∞∞∞∞∞Page 220
Aug 01/03 CES (1) If the pressure is less than 1667 psi (114.9355 bar):
- do a check on the lower ECAM DU to make sure that the engine pump fire valve 3046GK is not closed.
(a) If the engine pump fire valve is closed:
1 Do a check of the engine pump for a possible cavitation
_ condition (Ref. AMM TASK 29-00-00-280-006).
NOTE : A cavitation condition of the engine pump is possible
____ when the engine pump operates with the engine pump fire valve closed (if you set the ENG 1 (2) FIRE pushbutton on the Eng/APU fire panel), or with the reservoir below the low level (ECAM indication).
2 Push the ENG 2 FIRE P/BSW on panel 1WD (ENG/APU FIRE section
_ on the overhead panel 20VU) to open the engine pump fire valve 3046GK.
(b) If the engine pump fire valve is not closed:
- do a check for 28 VDC between: PUMP-Y, ENG 2 (3030GD) connector A/1 and PUMP-Y, ENG 2 (3030GD) connector A/3 (Ref. ASM 29-13/01).
1 If there is no 28 VDC:
_
a Replace the PUMP-Y, ENG 2 (3030GD) (Ref. AMM TASK 29-13-51-
_ 000-004) and (Ref. AMM TASK 29-13-51-400-004).
b Do a check of the engine pump for a possible cavitation
_ condition (Ref. AMM TASK 29-00-00-280-006).
NOTE : A cavitation condition of the engine pump is
____ possible when the engine pumpoperates with the engine pump fire valve closed (if you set the ENG 1
(2) FIRE pushbutton on the Eng/APU fire panel), or with the reservoir below the low level (ECAM indication).
2 If there is 28 VDC:
_
- replace the ENG 2 PUMP P/BSW (3703GD).
3 If the fault continues:
_
- do a check of the wiring between: PUMP-Y, ENG 2 (3030GD) connector A/3 and CB (3701GD) and repair the wiring as necessary (Ref. ASM 29-13/01).
(2) If the pressure is more than 1812 psi (124.9329 bar)
- do a check for continuity between: the PRESS SW-Y PUMP, ENG 2 (3074GD) connector A/1 and A/3 (Ref. ASM 29-13/01).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞29-13-00∞∞∞∞∞∞∞∞∞∞Page 221
Aug 01/01R CES
(a) If there is continuity:
- replace the PRESS SW-Y PUMP, ENG 2 (3074GD) (Ref. AMM TASK 29-13-17-000-040) and (Ref. AMM TASK 29-13-17-400-040).
(b) If there is no continuity:
- make sure that the wiring is not connected to GND between: PRESS SW-Y PUMP, ENG 2 (3074GD) connector A/1 and the DIODE (1156VD) connector 43 (Ref. ASM 29-13/01).
(c) If the wiring is connected to GND:
- repair the wiring as necessary.
B. Do the test as given in Para. 3. A. to make sure that operation is correct.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞29-13-00∞∞∞∞∞∞∞∞∞∞Page 222
Aug 01/01R
CES
TASK 29-13-00-810-805
Loss of the System Pressure of the Yellow Hydraulic System
1. Possible Causes
_______________
- PRESS SW-FLT CTL, Y (3151GN)
- SOL VALVE-LEAKAGE MEAS, Y (3150GP)
- wiring
- CTL RELAY (3811GX)
- TIME DELAY RELAY (3816GX)
- TIME DELAY RELAY (6MJ)
- pushbutton switch (1883GP)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power AMM 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 液壓(67)
