D. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure 71-00-00-710-003 Engine Automatic Start 71-00-00-710-004 Engine Manual Start 71-00-00-710-028 Engine Shutdown 71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 78-30-00-081-041 Make the Thrust Reverser Serviceable after
Maintenance 78-30-00-081-041 Make the Thrust Reverser Serviceable after Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
Maintenance 78-36-00-010-040 Opening of the Thrust Reverser Doors 78-36-00-010-040 Opening of the Thrust Reverser Doors 78-36-00-410-040 Closing of the Thrust Reverser Doors 78-36-00-410-040 Closing of the Thrust Reverser Doors 36-11-51-991-300 Fig. 401
3. Job Set-up
__________
Subtask 36-11-51-860-056
A. Aircraft Maintenance Configuration
(1)
Make sure that the electrical circuit is energized (Ref. TASK 24-41-00-861-002).
(2)
Make sure that the engine 1(2) is shut down for at least 5 minutes.
(3)
On the AIR COND panel 30VU:
-
make sure that the ENG 1(2) BLEED pushbutton switch is released (OFF legend is on),
-
make sure that the APU BLEED pushbutton switch is released (ON legend is off),
1EFF : ALL 1 36-11-51Page 407 1 1 Aug 01/04R 1 1 1CES 1
-make sure that the warning notice to tell persons not to operate the pneumatic system, is in position.
(4)
On the ENG panel 115VU:
-make sure that the warning notice to tell the persons not to start the engine 1(2), is in position.
(5)
On the HP ground connector:
-make sure that the warning notice to tell persons not to pressurize the pneumatic system, is in position.
(6)
On the MAINTENANCE panel 50VU:
-
make sure that the ON legend of the ENG/FADEC GND PWR 1(2) pushbutton switch is off,
-
make sure that the warning notice to tell persons not to energize the FADEC 1(2) is in position.
(7)
Make sure that the access platform is in position below the engine.
Subtask 36-11-51-010-053
B. Get Access
(1)
Make sure that the fan cowl doors are open (Ref. TASK 71-13-00-010-040): FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR
(2)
Make sure that the left thrust reverser door is open (Ref. TASK 78-36-00-010-040): FOR 1000EM1 451AL FOR 1000EM2 461AL
Subtask 36-11-51-040-050
C. Make sure that the thrust reverser is unserviceable (Ref. TASK 78-30-00-481-041).
1EFF : ALL 1 36-11-51Page 408 1 1 Aug 01/04R 1 1 1CES 1
Subtask 36-11-51-865-065
D. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
WARNING : OPEN CIRCUIT BREAKERS 1JH, 2JH1, 2JH2, 3JH1 AND 3JH2 (ENGINE 1
_______ AND 2 IGNITION SYSTEMS). THEN OPEN CIRCUIT BREAKERS 2KS1 AND 2KS2 (FADEC A AND EIU 1 AND 2) AND 4KS1 (FADEC B AND EIU 1). IF YOU DO NOT OBEY THIS SEQUENCE, THE ENGINE AUTOMATIC IGNITION- SYSTEM WILL OPERATE. THIS CAN CAUSE INJURY TO MAINTENANCE PERSONNEL.
CAUTION : YOU MUST OPEN THE CIRCUIT BREAKERS FOR THE PITOT PROBE BEFORE
_______ THE CIRCUIT BREAKERS FOR THE ENGINE INTERFACE UNIT (EIU). IF YOU DO NOT, YOU CAN CAUSE DAMAGE TO THE PITOT PROBES.
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU ENGINE/1 AND 2/IGN/SYS A 1JH A03 49VU AIR BLEED/ENG 1/CTL 3HA1 D12 49VU AIR BLEED/ENG 1/MONG 2HA1 D11 49VU ANTI ICE/PROBES/PITOT/1 3DA1 D02 122VU ANTI ICE/PROBES/2/PITOT 3DA2 Y14 122VU AIR BLEED/ENG 2/CTL 3HA2 Z23 122VU AIR BLEED/ENG 2/MONG 2HA2 Z22 122VU ANTI ICE/PROBES/3/PITOT 3DA3 Z16
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM PNEUMATIC 氣源 2(13)
