曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 5. Close-up________
 Subtask 30-11-00-410-057
 A. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.
 (2) Install the access panel 622WB (Ref. TASK 57-41-37-400-008).
 Subtask 30-11-00-865-066
 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1DL, 2DL, 5CV, 7CV, 2KD.
 Subtask 30-11-00-860-058
 C. Aircraft Configuration 
R R R  (1) Make sure that the ECAM upper DU, on Panel 4VU, does not show the warning message, WING A.ICE L(R) VALVE CLOSED. If necessary, on Panel 11VU, press the EMER CANC pushbutton switch on the ECAM Control Panel to cancel the message.
 (2) Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
R R  (3) Put a placard in position to tell aircraft crew that the RH wing anti-ice valve (10DL) is deactivated. The valve is in the OPEN position. 
R R R R R R  (4) Make an applicable entry in the Aircraft Technical Log that the RH anti-ice valve has been deactivated. The engine bleed must not be operated (except for engine start). If the crossbleed valve is open, the APU bleed must not be operated (except for engine start). If the engine or APU bleed is operated, heat damage to the slats can occur (Ref. FCOM 3-02-30).

 

 Subtask 30-11-00-942-060
 D. Removal of Equipment
 (1)
 Remove the safety barriers.

 (2)
 Remove the warning notice(s).

 (3)
 Remove the access platform(s).

 (4)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 1EFF : ALL 1 30-11-00Page 422 1 1 May 01/05R 1 1 1CES 1

 

 TASK 30-11-00-440-004
 Reactivation of the RH Wing Anti-Ice Control Valve 10DL from the OPEN position
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 1. Reason for the Job
__________________

 Refer to the MMEL TASK: 30-11-01
 Wing Ice Protection
 Anti-Ice Control Valve

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific safety barriers No specific warning notice No specific warning notices No specific access platform 3 m (9 ft. 10 in.) 98D27803500001 1 TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 19-010  USA AMS 5687 LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA (Ref. 20-31-00)
 1EFF : ALL 1 30-11-00Page 423 1 1 May 01/04R 1 1 1CES 1

 

 C. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
30-11-51-000-001 Removal of the Wing Anti-Ice Control Valve
 30-11-51-400-001 Installation of the Wing Anti-Ice Control Valve
 57-41-37-000-008 Removal of the Access Panel 522WB(622WB)
 57-41-37-400-008 Installation of the Access Panel 522WB(622WB)
 TSM 30 PB 101 (for corrective action)

R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 30-11-00-991-004 Fig. 401
 **ON A/C 301-399,

 30-11-00-991-004-A Fig. 401A
 **ON A/C ALL
 3. Job Set-up

__________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 (Ref. Fig. 401/TASK 30-11-00-991-004)
 **ON A/C 301-399,

 (Ref. Fig. 401A/TASK 30-11-00-991-004-A)R **ON A/C ALL

 

 Subtask 30-11-00-941-065
 A. Safety Precautions
 (1)
 Put the safety barriers in position.

 (2)
 Before you do work on the Ice Protection system, put warning notices in position to tell persons not to: - operate the pneumatic system - operate the engines - operate the slats - operate the APU switch.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ICE AND RAIN PROTECTION 防冰和排雨1(31)