Ice Detection - Location and Detail
Figure 015
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 30-00-00Page 25 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1
R Ice Detection - Location and Detail
R Figure 015A
R 1EFF : 401-499, 1 30-00-00 Page 26
1 1 Aug 01/05
1 1
1CES 1
R **ON A/C ALL
R 4. Power Supplies______________ **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
R (Ref. Fig. 016) **ON A/C 401-499,
R R (Ref. Fig. 016A) **ON A/C ALL
The referenced figure shows the power supply.
Ice and Rain Protection - Power Supplies Figure 016 (SHEET 1)
1EFF : 001-049, 051-099, 101-149, 151-199, 1 30-00-00Page 28 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1
Ice and Rain Protection - Power Supplies Figure 016 (SHEET 2)
1EFF : 001-049, 051-099, 101-149, 151-199, 1 30-00-00Page 29 1201-299, 301-399, 1Aug 01/05 1 1 1CES 1
R Ice and Rain Protection - Power Supplies
R Figure 016A (SHEET 1)
1EFF : 401-499, 1 30-00-00 Page 30
1 1 Aug 01/05
1 1
1CES 1
R Ice and Rain Protection - Power Supplies
R Figure 016A (SHEET 2)
1EFF : 401-499, 1 30-00-00 Page 31
1 1 Aug 01/05
1 1
1CES 1
AIRFOIL - DESCRIPTION AND OPERATION
___________________________________
1. General_______
(Ref. Fig. 001, 002)
The wings are the only airfoil sections to be protected against icing conditions. The leading edge slats 3, 4 and 5 are thermally anti-iced by a manually selected hot air system which directs engine bleed air into the leading edges of the slats.
Air for ice protection is supplied by the pneumatic system, the flow being controlled by a pressure control/shut-off valve. The pneumatically powered control/shut-off valves are selected open when power is supplied to the electrical circuit. Airflow trimming restrictors are fitted downstream of each valve.
The air leaving the control valves passes through ducts in the wing fixed leading edge to a telescopic duct which routes the air to the inboard end of the piccolo duct in slat 3. Air is distributed along slats 3, 4 and 5 by piccolo ducts interconnected by flexible couplings. The piccolo ducts release the air into the slats through holes along their forward length. The air flows around the forward area of the slat then goes through acceleration slots into the rear section. It is then released overboard through the holes in the bottom surface of the slat.
When only one engine is available to supply hot air, the pneumatic system crossfeed duct is used to supply the two wings from one engine.
The wing-ice protection system can only be operated continuously while the aircraft is flying, but can be tested on the ground for a limited period.
Airfoil Anti-icing
Figure 001
1EFF : ALL 1 30-10-00 Page 2
1 1 Feb 01/98
1 1
1CES 1
Air Distribution in Slats
Figure 002
1EFF : ALL 1 30-10-00 Page 3
1 1 Feb 01/98
1 1
1CES 1
WING ICE PROTECTION - DESCRIPTION AND OPERATION
_______________________________________________
1. General
_______
The wing ice protection system prevents ice on the leading edge of the slats 3, 4 and 5. The system, which is the same in the LH and the RH wing, uses hot air from the pneumatic system (Ref. 36-00-00). It is available in all flight conditions.
The two engines usually supply the pneumatic system with bleed air. If there is a failure, the cross-bleed valve opens and one engine can supply the two wings.
The system is only used during flight, but can be tested on the ground. To prevent heat damage to the slats, the ground test stops automatically after 30 seconds.
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ICE AND RAIN PROTECTION 防冰和排雨1(21)
