曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  fasteners. 
R  (e) TORQUE the nuts to between 20 and 25 lbf.in (0.22 and 0.28 
R  m.daN). 
R  (f) Do an electrical resistance check as follows: 
R  1_  Put one lead of the ohmmeter on the pressure switch (30).
R  2_  Put the other lead of the ohmmeter on the clamp (25).
R  3_  The resistance measured between the ohmmeter leads must be
R  0.0025 ohm or less. 
R  4_  Put one lead of the ohmmeter on the pressure switch (30).
R  5_  Put the other lead of the ohmmeter on the ground stud on the
R  channel bracket (40). 
R  6_  The resistance measured between the ohmmeter leads must be
R  0.0025 ohm or less. 
R  7_  If the resistance is more than 0.0025 ohm, remove the bonding
R  clamp (25) and clean the bonding surfaces again. 
R  8_  Do this procedure until the resistance indication is in the
R  correct range. 
R  (g) Lubricate the hydraulic tube (5) coupling with HYDRAULIC FLUIDS 
R  (Material No. 02-003). 
R  (h) Connect the hydraulic tube (5) to the switch (30). 
R  (i) TORQUE the coupling nut on the tube (5) to between 620 and 680 
R  lbf.in (7.00 and 7.68 m.daN). 
R  NOTE : Use a second wrench to hold the pressure switch (30) when____ 
R  you TORQUE the coupling nut on the tube (5). 
R  (j) Install the electrical connector (1074GK-A) on the switch (30) 
R  and tighten with your hand plus one-eighth of a turn.

 

 Subtask 29-11-17-865-058 R B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1702GK Subtask 29-11-17-710-052 R C. Test
 (1)
 Do an operational test of the Green hydraulic system (Ref. TASK 29-11-00-710-001).

 (2)
 During the dry motoring, make sure that there are no leaks from the LP pressure switch of the pump.

 (3)
 Make sure that the level of hydraulic fluid in the Green reservoir is correct. If necessary, fill the reservoir (Ref. TASK 12-12-29-611-001).

 5. Close-up
________
 Subtask 29-11-17-860-057

 A. Aircraft Maintenance Configuration
 (1)
 Remove the access platform(s).

 (2)
 Make sure that the work area is clean and clear of tool(s) and other items.

 Subtask 29-11-17-942-052
 B. Remove the safety precautions
 (1)
 Remove the warning notice(s).
 Subtask 29-11-17-410-052

 C.
 Close Access

 (1)
 Close the left fan cowl door:
 FOR 1000EM1
 close the door 437AL (Ref. TASK 71-13-00-410-040)

 (2)
 Close the door 195BB.

 

 

 PRESSURE GAGE - ACCUMULATOR AIR, GREEN POWER (1072GM) - REMOVAL/INSTALLATION
____________________________________________________________________________
 TASK 29-11-21-000-001
 Removal of the Accumulator-Air Pressure Gage (1072GM)
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
 -------------------------------------------------------------------------------
No specific blanking plugs
 No specific circuit breaker(s) safety clip(s)
 No specific warning notices
 No specific access platform 2.8 m (9 ft. 2 in.)

 B. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
 Configuration before Maintenance Action
 29-14-00-614-001 Depressurization of the Hydraulic Reservoirs
 29-23-00-860-001 Disconnection of the Isolation Coupling of the Power
 Transfer Unit (PTU)
 32-12-00-010-001 Open the Main Gear Doors for Access

R **ON A/C 001-001, 051-052,
 29-11-21-991-001 Fig. 401 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓2(32)