-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-make sure that the MODE switch (6KS) is in the NORM (center) position
 -put the MASTER 2 switch to the ON position.
 19. On the MCDU:
 -push in the key adjacent to the DISPLAY NON-MONITORING TEST RESULTS indication
 -make sure that the indication FRV, J8 ECU is not shown
 -push in the key adjacent to the RETURN indication.
 20.
 On the panel 115VU, put the MASTER 2 switch to the OFF position.

 21.
 On the panel 50VU:

 -push in the ENG/FADEC GND PWR 2 P/BSW.

22.
 On the MCDU:

 -push in the key adjacent to the RETURN indication until the SYSTEM REPORT/TEST page is shown -this indication is shown:
 ***** WARNING *****
 ***** TEST ACTIVE *****

 -when the test has stopped this indication is shown: A NON-MONITORING TEST WAS PERFORMED DUE TO INSUFFICIENT STARTER AIR PRESSURE OR DUE TO A STARTER AIR VALVE FAILURE
-
the test results are shown

-
the TEST COMPLETE page is shown.

-
the ON light of the ENG/FADEC GND PWR2 P/BSW goes off.

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-00Page 408 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1

 -------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-
push in the key adjacent to  - the FUEL page is shown
 the FUEL indication

 -
push in the NEXT PAGE key - the second FUEL page is shown

 -
push in the key adjacent to  - the FLSS STATUS page is shown
 the FLSS STATUS indication

 -make sure that none of these
 messages are shown:
 L SURGE SENSOR 28QJ1
 R SURGE SENSOR 28QJ2
 L INN TEMP SENSOR 29QJ1
 R INN TEMP SENSOR 29QJ2
 L OUT TEMP SENSOR 30QJ1
 R OUT TEMP SENSOR 30QJ2
 L LO LEVEL SENSOR 38QJ1
 R LO LEVEL SENSOR 38QJ2

 -
push in the key adjacent to
 RETURN until the CFDS MENU
 page is shown

 -
push in the MCDU MENU key. - the MCDU MENU is shown.

R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-21-00Page 409 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 **ON A/C 301-399,

 Subtask 28-21-00-040-050-A
 A. Check Operation of the Recirculation System When Main Fuel Pump 2 does not Operate
 (1) Do this test:
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1.
 On the MCDU, get access to the ENG page (Ref. TASK 31-32-00-860-012).

 2.
 On the panel 50VU, make sure that the ENG/FADEC GND PWR/1 pushbutton switch (P/BSW) is released out.

 3.
 On the MCDU:

 -
push in the key adjacent to the FADEC 1A indication

 -
push in the key adjacent to the FADEC TEST indication

-
push in the key adjacent to the PUSH BUTTON TO START TEST> indication.

NOTE : The tests that follow are
____ usually done without an air pressure supply to the engine starter motor (non-engine motor test). If air pressure is supplied, the engine fan blades will turn during
On the panel 50VU, the ENG/FADEC GNDPWR/1 P/BSW ON light is on.
-
the ENGINE 1 MAIN MENU is shown

-
the FADEC TEST ENGINE 1 CHANNEL Apage is shown

-this indication is shown:PUT THE MODE SELECTORSWITCH TO <NORM> PLACE THE MASTER LEVER SWITCH TO <ON>
 1EFF : 301-399, 1 28-21-00Page 410 1 1 May 01/05R 1 1 1CES 1

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
R R R  the tests. You must obey the applicable safety precautions. 
R R R R  4. On the panel 115VU: - make sure that the MODE switch (6KS) is in the NORM (center) position 
R R R R R R R R R R R R R  - put the MASTER 1 switch to the ON position. 
R  5. On the MCDU: 
R R R  - push in the key adjacent to the DISPLAY NON-MONITORING TEST RESULTS indication 
R R R  - make sure that the indication J7, FRV (SOL1), ECU is not shown 
R R  - push in the key adjacent to the RETURN indication. 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油2(110)