4. Procedure
_________

R **ON A/C 001-049, 101-105,
 Subtask 22-70-00-970-066
 A. Uploading of the FM Data NOTE : This procedure is for the FMGC1. For the FMGC2, which is
____ identical, use the indications between the parentheses.
 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the center pedestal, on the MCDU1(2):
 -turn the BRT potentiometer to adjust the brightness.
 2.
 Open the circuit breakers 10CA1, 10CA2, 11CA1 and 11CA2.

 3.
 On the FLIGHT MANAGEMENT SYSTEM LOAD (964-0400-0XX):

 -set the ON/OFF switch to OFF.
 -connect the connecting cable to the loader connector.
 4. On the panel 52VU:
 -remove the FMS LOAD blanking plate.
 -connect the connecting cable to the SYST1(2) connector.
 5.
 Close the circuit breaker 11CA1 (11CA2).

 6.
 On the carry-on loader:

-set the ON/OFF switch to ON.
7. Put the floppy disk into the loader.
MCDU1 and 2 go blank.
On the carry-on loader:
-all lights flash, then go off.
-the RDY indicator light comes on.

 -------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
8.
 Close the circuit breaker 10CA1 (10CA2).

9.
 On the carry-on loader:

 -eject the floppy disk.
 -set the ON/OFF switch to OFF.
 10.
 Open the circuit breakers 10CA1 (10CA2) and 11CA1 (11CA2).

 11.
 On the panel 52VU:

 -disconnect the carry on loader connecting cable
 -install the FMS LOAD blanking plate.
 12.
 Close the circuit breakers 10CA1, 10CA2, 11CA1, 11CA2 and wait 1 minute.

 13.
 On the center pedestal, on the MCDU1(2):

 -
push the MCDU MENU mode key.

-
push the line key adjacent to the FMGC indication.

 -
push the DATA mode key.

-
push the line key adjacent to the A/C STATUS indication.

-the power-up test of the FMGC1(2)starts.
 -at the end of this test, the triple click aural warning sounds. On the carry-on loader the PROG indicator light comes on.
 -When all the data are put into the computer (a time duration of 25 minutes can be necessary), the RDY and PROG indicator lights go off and the COMP indicator light comes on.
The MCDU MENU page comes into view.
An FM page comes into view.
The DATA INDEX page comes into view.
The A/C STATUS page comes into view.

R **ON A/C 051-061,

R  Subtask 22-70-00-970-066-A 
R  A. Uploading of the FM Data 
R  NOTE : This procedure is for the FMGC1. For the FMGC2, which is____ 
R  identical, use the indications between the parentheses. 
R  NOTE : After the loading of one of the FMGCs, you can use the CROSSLOAD____ 
R  function (Ref. TASK 22-70-00-610-009) to directly put the data 
R  into the other FMGC. 
R  -------------------------------------------------------------------------------
R  ACTION  RESULT 
R  -------------------------------------------------------------------------------

R  1. On the center pedestal, on the 
R  MCDU1(2): 
R  - turn the BRT potentiometer to 
R  adjust the brightness. 
R  2. Open the circuit breakers 10CA1,  MCDU1 and 2 go blank. 
R  10CA2, 11CA1 and 11CA2. 
R  3. On the FLIGHT MANAGEMENT SYSTEM 
R  LOAD (964-0400-0XX): 
R  - set the ON/OFF switch to OFF. 
R  - connect the connecting cable to 
R  the loader connector. 
R  4. On the panel 52VU: 
R  - remove the FMS LOAD blanking 
R  plate. 
R  - connect the connecting cable to 
R  the SYST1(2) connector. 
R  5. Close the circuit breaker 11CA1 
R  (11CA2). 
R  6. On the carry-on loader:  On the carry-on loader: 
R  - set the ON/OFF switch to ON.  - all lights flash, then go off. 
R  7. Put the floppy disk into the  - the RDY indicator light comes on. 
R  loader. 

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM AUTO FLIGHT 自動飛行3(2)