(a)  
The prepare to do a weather radar operational test.

 (b)  
The weather radar system self-test.

 (c)  
The test of the indicator controls.

 (2)  
The self-test uses the TEST mode switch on the WXR control panel in the TEST position. In the TEST mode the self-test circuits monitor the performance of the weather radar system.

 (3)  
The weather radar control panel is referred to as the WXR control panel.

 (4)  
During the self-test the weather radar system operates as follows:

 (a)  
It makes a test pattern which finds most system failures without test equipment.

 (b)  
The receiver/transmitter operates for 1 second.

 (c)  
A special test pattern is made on the weather radar indicators.

 B.  References
 (1)  
AMM 21-58-00/501, Equipment Cooling System

 (2)  
AMM 24-22-00/201, Manual Control

 (3)  
AMM 34-41-00/501, Inertial Navigation System

 C.  Prepare for the weather radar operational test:
 (1)  
Supply electrical power (AMM 24-22-00/201).

 (2)  
Supply equipment cooling (AMM 21-58-00/501).

 CAUTION: MADE SURE THE EQUIPMENT COOLING SYSTEM OPERATES
_______ BEFORE THE ELECTRONIC SYSTEMS ARE OPERATED. THE EQUIPMENT COOLING SYSTEM MUST BE SET FOR CORRECT COOLING. IF THESE CAUTION ARE NOT OBEYED, DAMAGE TO THE ELECTRONIC SYSTEMS CAN OCCUR.
 (3) Prepare each of the INUs for operation (AMM 34-41-00/501).
 (a)  Align to at least coarse align mode.
 1)  Make sure the attitude flags on the captain's and the first officer's ADI are out of view.
 (4)  Close these circuit breakers:
 (a)  P7 Overhead Circuit Breaker Panel
 1) WEA RDR R/T 1

 EFFECTIVITY

 AF 160, 162-171, 183, 184  CONFIG 4  01 Page 501  Sep 25/9434-43-00
 2) WEA RDR R/T 2 3) WEA RDR IND 1 4) WEA RDR IND 2 5) CAPT FLT INST SW RELAYS -ATT COMP STAB 6) F/O FLT INST SW RELAYS -ATT COMP STAB
 (5)  
Set the ATT/COMP STAB switch on the captain's main instrument panel to CAPT 1 F/O 2.

 (6)  
AF 160, 162-171; Set the controls and switches on the WXR control panel for the operational test as follows:

 (a)  
Mode select switch - TEST

 (b)  
SYS transfer switch - 1

 (c)  
TILT control - 0 degrees

 (d)  
GAIN control - CAL

 (e)  
GND CLTR SPRS switch - OFF

 (7)  
AF 183, 184; Set the controls and switches on the WXR control panel for the operational test as follows:

 (a)  
TEST MODE switch - pressed

 (b)  
SYS transfer switch - OFF

 (c)  
TILT control - 0 degree

 (d)  
GAIN control - 12 o'clock

 (e)  
GND SPR switch - OFF

 (8)  
Position the controls on both indicators as follows:

 (a)  
AF 160, 162-171;
 PWR switch - off (released)

 (b)  
MKR intensity control - midposition

 (c)  
INT control - midposition

 (d)  
Range switch - 40

 (e)  
M/S switch - master mode position

 (f)  
AF 160, 162-171; AZ switch - off position (azimuth lines displayed)

 (g)  
AF 160, 162-171;
 HOLD switch - off (mode disabled)

 (h)  
Offset display select switch - FWD

 D. Procedure
 (1)  Do the weather radar system self-test.
 (a)  
AF 160, 162-171; Set the PWR switches on both indicators to ON.

 (b)  
AF 183, 184; Set the SYS switch to 1 on the WXR control panel. 1) Make sure the displays on each weather radar indicator are

 as follows (Fig. 501): a) Antenna does a complete left-to-right scan test pattern on indicators. b) The tilt angle will show +15.0, then -15.0 and stops at
 0. c) A TEST message shows in slot 1.
 2) Make sure both indicator test patterns are shown: a) A color bar shows green, yellow and red.
 EFFECTIVITY

 AF 160, 162-171, 183, 184  CONFIG 4  01 Page 502  Sep 25/9434-43-00
 b)  Blue azimuth lines, range mark, alphanumeric messages and test patterns show.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747飛機維護手冊AMM CHAPTER 34 - NAVIGATION 第34章導航3(141)