国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽

  • 熱門標簽

當前位置: 主頁 > 航空資料 > 飛行資料 >

時間:2011-03-14 16:05來源:藍天飛行翻譯 作者:admin
曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

If altitude intervention is selected when on-approach logic is active, typically after the airplane has sequenced the first approach waypoint, level flight is commanded until reaching the VNAV path, then the airplane captures the VNAV path.
Note: When a PROC HOLD is active, VNAV altitude intervention functions
normally by causing the next waypoint altitude constraint to be deleted and
a descent to be initiated.
Copyright . The Boeing Company. See title page for details.
October 31, 2006 FCT 737 (TM) 5.41

Non - ILS Approach - One Engine Inoperative
Maneuvering before and after the final approach fix with one engine inoperative is the same as for an all engine non-ILS approach.

Procedure Turn and Initial Approach
Cross the procedure turn fix at flaps 5 and flaps 5 maneuvering airspeed. If a complete arrival procedure has been selected via the CDU, the initial approach phase may be completed using LNAV and VNAV path, or other appropriate modes.

Vertical Path Construction
This section describes typical final approach vertical profile (path) construction criteria as they relate to flying instrument approaches using VNAV. This information may also be useful to pilots who wish to fly the vertical path using V/S.
Where there is a glide path (GP) angle coded in the navigation database, the FMC builds the descent path upward and back in the direction of the FAF by starting at the location of the missed approach waypoint (MAP) and its associated altitude constraint. The FMC calculates this path using the coded GP angle, also called the vertical angle. The MAP is normally shown on the LEGS page as a RWxx or MXxx waypoint. In some cases a named waypoint is used as the MAP. A GP angle is coded in the navigation database for nearly all straight-in approach procedures.
This GP angle is normally defined by the state authority responsible for the approach procedure and provides a continuous descent at a constant flight path angle for a final approach path that complies with minimum altitudes at intermediate step down fixes. The typical GP angle is approximately 3.00°, but can vary from 2.75° to 3.77°.
The projection of the vertical path upward and back toward the FAF along this coded GP angle stops at the next higher limiting altitude in the vertical profile. This limiting altitude is the more restrictive of the following:
.  
the “At” altitude on the constrained waypoint preceding the MAP

.  
the first approach waypoint for the selected approach procedure.

.  
the crossing altitude on the next “at or above” constrained waypoint
preceding the FAF.

 

The following examples show typical VNAV final approach paths where there is a GP angle in the navigation database. The first example shows an RWxx missed approach waypoint. The second example below shows the VNAV final approach path where there is a missed approach waypoint before the runway. Note that in the second case the projected path crosses the runway threshold at approximately 50 feet. VNAV guidance is level flight, however, when the airplane passes the missed approach point. Both examples are for “At” altitude constraints at the FAF.
Copyright . The Boeing Company. See title page for details.
5.42  FCT 737 (TM) October 31, 2006

FACF

 

Threshold
FACF FAF  MAP
crossing height (MXxx)
Note:  The final approach course fix (FACF) is typically located on the final approach course approximately 7 NM before the FAF. The FAF referred to in the following procedures refers to the charted FAF and is intended to mean the point at which the final approach descent is begun.
For the non-ILS approach procedures with an “At” constraint altitude at the FAF, a short, level segment between the FAF and the final glide path (also called a “fly-off”) may result. For the ILS procedure, the constraint altitude at the FAF is computed to be the crossing altitude of the glide slope.
For procedures where both the FAF and FACF are coded with “at or above” altitude constraints, the crew should consider revising the FACF altitude constraint to “at” (hard constraint). This enables a shallower path before the FAF, permitting a normal deceleration for flap and gear extension. Example: In the diagram above, if both the FACF and the FAF contain “xxx/4000A” waypoint constraints, the crew should change “4000A” to “4000” at the FACF to modify the path for a more normal deceleration.
Copyright . The Boeing Company. See title page for details.
October 31, 2006 FCT 737 (TM)  5.43

737 Flight Crew Training  Manual
Crews can expect to see several other variations of approach path construction:
.  
approaches where the FAF has an “at or above” waypoint altitude
 
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址:737機組訓練手冊 Flight Crew Training Manual FCTM(74)

国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽
97免费视频在线播放| 久久精品成人欧美大片| 久久久精彩视频| 亚洲一区精品电影| 国产奶头好大揉着好爽视频| 国产精品三级网站| 欧美在线激情网| 久久精品国产一区二区三区不卡| 精品自在线视频| 国产在线精品一区免费香蕉| 国产精品免费网站| 狠狠色噜噜狠狠狠狠色吗综合| 色偷偷9999www| 青青草一区二区| 视频直播国产精品| 欧美性久久久久| 久久久精品国产亚洲| 青青草原一区二区| 久久色在线播放| 激情婷婷综合网| 久久香蕉国产线看观看av| 免费看国产一级片| 欧美成aaa人片在线观看蜜臀| 狠狠色综合一区二区| 国产精品久久亚洲7777| 国产又黄又爽免费视频| 久久国产精品网站| 国产精品亚洲一区二区三区| 亚洲一区二区三区视频| 久无码久无码av无码| 欧美一级免费在线观看| 日韩在线欧美在线国产在线| 欧美精品v日韩精品v国产精品| 国产精品欧美久久久| 国产视频一区二区不卡| 久精品免费视频| 97碰在线视频| 日本欧美精品在线| 日韩在线高清视频| 激情五月宗合网| 欧美激情一二三| 国产精品99久久久久久大便| 琪琪亚洲精品午夜在线| 国产精品第一第二| www.浪潮av.com| 日韩和欧美的一区二区| 国产精品久久综合av爱欲tv| 国产免费黄色av| 亚洲a一级视频| 久久精品99久久久久久久久| 国产淫片av片久久久久久| 久久久久成人精品| 久久亚洲a v| 日韩精品国内| 久久国产精品影片| 成人精品在线视频| 日韩久久久久久久久久久久| 国产精品久久不能| 99免费视频观看| 欧美在线视频导航| 欧美激情国产高清| 国产成人精品日本亚洲专区61| 欧美成人蜜桃| 亚洲欧美日韩不卡一区二区三区 | 国产伦精品一区二区三区高清版| 亚洲综合在线中文字幕| 日韩一区在线视频| 成人动漫在线观看视频| 人人妻人人添人人爽欧美一区| 欧美成人在线影院| 久久国产成人精品国产成人亚洲| 国产日韩欧美大片| 青青草成人在线| 亚洲精品蜜桃久久久久久| 国产精品日韩一区二区免费视频| 成人h视频在线观看| 欧美日韩在线播放一区二区| 亚洲熟妇无码一区二区三区| 国产精品手机播放| aaa免费在线观看| 国内精品久久久久久| 欧美一级片久久久久久久| 欧美激情综合亚洲一二区| 日韩在线免费视频观看| 99视频免费观看蜜桃视频| 黄色一级片在线看| 日韩欧美99| 五月天亚洲综合情| 欧美激情亚洲视频| 国产精品第七影院| 久久色免费在线视频| 国产suv精品一区二区三区88区| 国产精品中文字幕久久久| 黄网站色视频免费观看| 日本一区二区三区视频在线播放| 中文字幕中文字幕在线中心一区 | 日本www高清视频| 一区精品在线| 操91在线视频| 北条麻妃一区二区三区中文字幕| 99精品一区二区三区的区别| 国产一级片91| 黄色污污在线观看| 欧美在线亚洲在线| 日韩精品一区二区三区丰满| 亚洲精品国产精品久久| 亚洲一卡二卡三卡| 精品国产中文字幕| 久青草国产97香蕉在线视频| 日韩视频―中文字幕| 久久99精品久久久久久久久久| 久久久在线视频| 97精品一区二区视频在线观看| 国产精品中出一区二区三区| 国产在线视频欧美一区二区三区| 欧美重口乱码一区二区| 欧美资源在线观看| 欧洲成人一区二区| 欧洲中文字幕国产精品| 日本wwwcom| 青青草久久网络| 欧美性一区二区三区| 欧美日韩一区在线播放| 欧洲精品国产| 免费在线成人av| 国产综合在线观看视频| 精品一区久久久久久| 国产日韩欧美日韩| 成人免费毛片播放| av在线不卡一区| 国产经典久久久| 久久久久资源| 久久久97精品| 国产精品第一视频| 欧美激情一区二区三区久久久| 亚洲午夜精品久久| 日本一区二区三区四区五区六区 | 欧美日韩国产91| 中文精品无码中文字幕无码专区| 在线天堂一区av电影| 亚洲熟妇av日韩熟妇在线| 岛国视频一区| 欧美最猛性xxxxx(亚洲精品)| 欧美成ee人免费视频| 蜜臀av.com| 99在线视频首页| 色噜噜狠狠色综合网图区| 国产精品久久久久久久久久小说 | 国产精品99蜜臀久久不卡二区| 久久久久久a亚洲欧洲aⅴ| 久久精品国产99国产精品澳门| 国产精品精品久久久久久| 亚洲最大福利视频网站| 日韩av电影在线播放| 欧美另类一区| 国产乱子伦精品无码专区| 国产高清自拍99| 国产精品美女主播| 中文字幕在线亚洲三区| 日韩在线一级片| 欧美日韩一区二区三区电影| 国产三级中文字幕| 91国内精品久久| 国产精品视频自拍| 亚洲伊人婷婷| 欧美黄网在线观看| 91精品啪aⅴ在线观看国产| 日韩中文在线视频| 在线精品亚洲一区二区| 日韩精品―中文字幕| 国产欧美一区二区三区久久人妖 | 久久久久久网站| 精品久久久久久一区| 日本丰满少妇黄大片在线观看| 蜜桃免费区二区三区| 91免费视频网站在线观看| 国产精品入口日韩视频大尺度| 中文字幕一区二区三区四区五区六区 | 欧美日韩一道本| αv一区二区三区| 久久久成人精品视频| 中文字幕中文字幕在线中心一区 | 久久狠狠久久综合桃花| 久久99视频精品| 欧美日韩福利在线| 91九色国产视频| 久久综合久久八八| 欧美有码在线视频| 99国产精品久久久久老师| 久久精品中文字幕免费mv| 亚洲av综合色区| 国产日产欧美精品| 久久精品免费播放| 欧美一区二区高清在线观看| 国产精品一区二区三区久久久| 日韩少妇与小伙激情| 婷婷久久青草热一区二区| 福利视频一二区| 欧美另类第一页| 欧美日韩日本网|