Procedure Turn
On most approaches the procedure turn must be completed within specified limits, such as within 10 NM of the procedure turn fix or beacon. The FMC depicted procedure turn, or holding pattern in lieu of procedure turn, complies with airspace limits. The published procedure turn altitudes are normally minimum altitudes.
The FMC constructs the procedure turn path based upon predicted winds, a 170
knot airspeed and the “excursion” distance in the nav database for the procedure. Adjust time outbound for airspeed, wind effects, and location of the procedure turn fix. If the procedure turn fix is crossed at an excessively high ground speed, the procedure turn protected airspace may be exceeded. The procedure turn should be monitored using the map to assure the airplane remains within protected airspace.
Stabilized Approach Recommendations
Maintaining a stable speed, descent rate, and vertical/lateral flight path in landing configuration is commonly referred to as the stabilized approach concept.
Any significant deviation from planned flight path, airspeed, or descent rate should be announced. The decision to execute a go-around is no indication of poor performance.
Note: Do not attempt to land from an unstable approach.
Copyright . The Boeing Company. See title page for details.
FCT 737 (TM) October 31, 2006
Recommended Elements of a Stabilized Approach
The following recommendations are consistent with criteria developed by the Flight Safety Foundation.
All approaches should be stabilized by 1,000 feet above airport elevation in instrument meteorological conditions (IMC) and by 500 feet above airport elevation in visual meteorological conditions (VMC). An approach is considered stabilized when all of the following criteria are met:
.
the airplane is on the correct flight path
. only small changes in heading/pitch are required to maintain the correct
flight path
.
the airplane speed is not more than VREF + 20 knots indicated airspeed
and not less than VREF
.
the airplane is in the correct landing configuration
.
sink rate is no greater than 1,000 fpm; if an approach requires a sink rate
greater than 1,000 fpm, a special briefing should be conducted
.
power setting is appropriate for the airplane configuration
.
all briefings and checklists have been conducted.
Specific types of approaches are stabilized if they also fulfill the following: 737-300 - 737-500
.
ILS approaches should be flown within one dot of the glide slope and
localizer, or within the expanded localizer scale (as installed)
737-600 - 737-900
.
ILS approaches should be flown within one dot of the glide slope and
localizer, or within the expanded localizer scale
.
during a circling approach, wings should be level on final when the
airplane reaches 300 feet above airport elevation.
Unique approach procedures or abnormal conditions requiring a deviation from the above elements of a stabilized approach require a special briefing.
Note: An approach that becomes unstabilized below 1,000 feet above airport
elevation in IMC or below 500 feet above airport elevation in VMC
requires an immediate go-around.
These conditions should be maintained throughout the rest of the approach for it to be considered a stabilized approach. If the above criteria cannot be established and maintained at and below 500 feet AFE, initiate a go-around.
At 100 feet HAT for all visual approaches, the airplane should be positioned so the flight deck is within, and tracking to remain within, the lateral confines of the runway edges extended.
As the airplane crosses the runway threshold it should be:
.
stabilized on target airspeed to within + 10 knots until arresting descent
rate at flare
. on a stabilized flight path using normal maneuvering
.
positioned to make a normal landing in the touchdown zone (the first
3,000 feet or first third of the runway, whichever is less).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737機組訓練手冊 Flight Crew Training Manual FCTM(58)
