曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(or remove) shims as necessary to give the
correct latch force.
Shim, strike, Pt. No. 22-5600-00-15 and
Pt. No. 22-5600-00-18.
Shims may be sanded to reduce their
thickness.
(3) Lift the strike block assembly into position. Do not trap the cable for the canopy lock
micro-switch.
(4) Install the screws which hold the strike block
assembly to the fuselage.
(5) Do a latch force test. Paragraph 3
5. Adjust The Canopy Warning Light Micro-Switch
Detail Steps/Work Items Key Items
(1) Set the GEN/BAT switch to ON.
(2) Close the canopy. Make sure both hooks are engaged past
the detent.
(3) Bend the micro-switch actuator in the
necessary direction to operate the warning
light correctly.
Both hooks must be engaged past the
detent before the warning light goes out.
(4) Open the canopy. And close the canopy. Make sure both hooks are engaged past
the detent when the light goes off.
(5) Make sure the canopy warning light operates
correctly.
(6) Set the GEN/BAT switch to OFF.
DA20-C1 AMM
Doors
Doc # DA201-C1
Rev. 9 52-10-00 Page 205
29 Apr 2004
Strike Assembly
Roller Bearing
Pivot Pin
Micro
Switch
Spring Pin Housing
Conical Washers
Outer Side Plate
Inner Side Plate
Spacer
Stop
Hook Assembly
Adjusting Screw
Strike Block
Grip
Shim
Figure 2: Canopy Latch Installation without Outside Handles
Doors
DA20-C1 AMM
Page 206
29 Apr 2004 52-10-00 Doc # DA201-C1
Rev. 9
Hook Assembly
Grip
Inner Side Plate
Bronze Bushing
(non-removable)
Outside Handle
Shim (s)
Spacing Block
Guide Plate
Cover Plate
Travel Limiting Screw
Strike Assembly
Roller Bearing
Pivot Pin
Micro
Switch
Strike Block
Strike Plate
Shim
Figure 3: Canopy Latch Installation with Outside Handles
DA20-C1 AMM
Doors
Doc # DA201-C1
Rev. 15 52-10-00 Page 207
30 Apr 2009
6. Remove/Install the Sliding Side Window
A. Remove the Sliding Side Window
Detail Steps/Work Items Key Items
(1) Remove the air scoop lock as follows:
(a) Remove the screw and nut.
(b) Remove two (2) thin washers and a nylon
washer.
(c) Remove air scoop lock.
See Figure 4
(2) Remove the clear and tinted sliding window
air scoop as follows:
(a) Remove the screw, washer, and nut from
the sliding window air scoop hinge.
(b) Remove the hinge.
(c) Remove the clear/tinted sliding window
air scoop
See Figure 4
(3) Remove the guide rails as follows:
(a) Remove the nylon screws.
(b) Remove the guide rails from the canopy
window.
See Figure 4
(4) Remove the sliding window as follows:
(a) Remove the screws.
(b) Remove the hinge block.
(c) Remove the sliding window knob.
(d) Remove the sliding window.
See Figure 4
B. Install the Sliding Side Window
Detail Steps/Work Items Key Items
(1) Assemble the sliding window as follows:
(a) Install the sliding window knob into the
sliding window.
(b) Install the hinge block using two screws.
See Figure 4
(2) Install the sliding window with the guide rails.
(3) Secure the guide rails with eight (8) nylon
screws.
Doors
DA20-C1 AMM
Page 208
30 Apr 2009 52-10-00 Doc # DA201-C1
Rev. 15
Detail Steps/Work Items Key Items
(4) If the sliding window installed does not
include the clear/tinted sliding window air
scoop and the air scoop lock, install as
follows:
(a) Install the hinge with the screw, washer,
and nut.
(b) Install the clear/tinted sliding window air
scoop.
(c) Install the air scoop lock with screw, nut
two (2) thin washers, and a nylon washer.
DA20-C1 AMM
Doors
Doc # DA201-C1
Rev. 15 52-10-00 Page 209
30 Apr 2009
Figure 4: Sliding Window Assembly
Doors
DA20-C1 AMM
Page 210
30 Apr 2009 52-10-00 Doc # DA201-C1
Rev. 15
Intentionally left blank
DA20-C1 AMM
Doors
Doc # DA201-C1
Rev. 9 52-40-00 Page 1
29 Apr 2004
CHAPTER 52-40
ACCESS PANELS
1. General
The DA20-C1 has a small number of access panels. The panels give access for maintenance.
Most panels are GFRP moldings. Self-tapping screws or camlock (quick-release) fasteners hold
the panels. Refer to Chapter 71-10 for data about the engine cowlings.
Figure 1 shows the access panel locations on the bottom of the airplane.
Figure 1: Access Panel Locations On The Bottom Of The Airplane
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石20系列AMM 2(49)