曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

A. Inpection
Detail Steps/Work Items Key Items
(1) Remove main wheel. Refer to paragraph 2.B.
CAUTION: WHEEL BEARING GREASES SHOULD NOT BE INTERMIXED WITH
EACH OTHER. IF USING OTHER APPROVED GREASE,
COMPLETE REMOVAL OF CONTAINED GREASE AND BEARING IS
REQUIRED.
(2) Inspect bearings. Make sure there is
enough grease on the bearing.
Apply grease on bearing. Use Mobil
Aviation Grease SHC 100.
(3) If felt grease seals are used, lightly coat all
surfaces of the seals with bearing grease
prior to installing.
(4) If rubber lip seals are used, lubricate the
bearing seal bore with bearing grease.
(5) Install main wheel. Refer to paragraph 2.C.
B. Cleaning
Detail Steps/Work Items Key Items
(1) Remove main wheel. Refer to paragraph 2.B.
CAUTION: DO NOT USE HIGH PRESSURE SPRAY WASH EQUIPMENT. THE
USE OF HIGH PRESSURE SPRAY WASH MAY INJECT SOAP
SOLUTION AND WATER INTO BEARINGS AND OTHER INTERNAL
CAVITIES RESULTING IN CORROSION AND REDUCED SERVICE
LIFE.
(2) Hand wash wheels and brakes with a mild
soap and water solution.
Rinse with low-pressure spray.
(3) Install main wheel. Refer to paragraph 2.C.
Landing Gear
DA20-C1 AMM
Page 214
30 Apr 2009 32-40-00 Doc # DA201-C1
Rev. 15
Intentionally left blank
DA20-C1 AMM
Lights
Doc # DA201-C1
Rev. 0 33-TITLE Page 1
19 Dec 1997
CHAPTER 33
LIGHTS
Lights
DA20-C1 AMM
Page 2
19 Dec 1997 33-TITLE Doc # DA201-C1
Rev. 0
Intentionally left blank
DA20-C1 AMM
Lights
Doc # DA201-C1
Rev. 0 33-CONTENTS Page 1
19 Dec 1997
TABLE OF CONTENTS
CHAPTER 33-00 LIGHTS - GENERAL ...................................................................................................1
1. General .............................................................................................................................1
2. Description ........................................................................................................................1
CHAPTER 33-20 COCKPIT LIGHTING....................................................................................................1
1. General .............................................................................................................................1
2. Description ........................................................................................................................1
TROUBLE SHOOTING...............................................................................................................101
1. General .........................................................................................................................101
MAINTENANCE PRACTICES ....................................................................................................201
1. General .........................................................................................................................201
2. Remove/Install The General Instrument Light/Map Light Module ................................201
CHAPTER 33-40 EXTERIOR LIGHTS .....................................................................................................1
1. General .............................................................................................................................1
2. Description ........................................................................................................................1
TROUBLE SHOOTING...............................................................................................................101
1. General .........................................................................................................................101
MAINTENANCE PRACTICES ....................................................................................................201
1. General .........................................................................................................................201
2. Remove/Install The Taxi Light ......................................................................................201
3. Remove/Install The Landing Light ................................................................................202
4. Adjust The Position Of The Taxi/Landing Light Beam..................................................204
5. Replace A Bulb In The Wing Tip...................................................................................205
6. Remove/Install The Light Unit In The Wing Tip............................................................205
7. Remove/Install The Power Unit For The Anti-Collision Lights......................................207
Lights
DA20-C1 AMM
Page 2
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石20系列AMM 2(10)