曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

OFF
OFF
OFF
OFF
LAMP TEST 2 OFF
FIRE TEST
STALL TEST
AURAL WARNING TEST 1
AURAL WARNING TEST 2
LAMP TEST 1
OFF
OFF
OFF
OFF
OFF
LAMP TEST 2 OFF
FIRE TEST
STALL TEST
AURAL WARNING TEST 1
AURAL WARNING TEST 2
LAMP TEST 1
OFF
OFF
OFF
OFF
OFF
LAMP TEST 2 TEST
STALL TEST
AURAL WARNING TEST 1
AURAL WARNING TEST 2
LAMP TEST 1
OFF
OFF
OFF
OFF
LAMP TEST 2 OFF
After 20 seconds
After 20 seconds
LAMP TEST 1 TEST
FIRE TEST OFF
TEST CONTROL 1/1
TEST CONTROL 1/1
TEST CONTROL 1/1
LIGHTING
Flight Crew Operating Manual REV 41, Jul 08, 2004
CSP 700−6
Volume 2
16−10−16
PASSENGER SIGNS/EMERGENCY LIGHTS PANEL
The PASS SIGNS switches for the no smoking and seat belts are located on the PASS
SIGNS/EMER LTS panel.
GF1610_021
NO SMKG SWITCH
ON
OFF
AUTO
the no smoking lights automatically, based
on airplane configuration.
SEAT BLTS SWITCH
ON
OFF
AUTO
the seat belt lights automatically, based on
airplane configuration.
− Turns on all no smoking signs.
− Turns off all no smoking signs.
− NO SMKG switch will activate
− Turns on all seat belt signs.
− Turns off all seat belt signs.
− SEAT BLTS switch will activate
PASS SIGNS EMER LIGHTS
NO SMKG SEAT BELTS
OFF
AUTO
ON
OFF
AUTO
ON
OFF
ARM
ON
Passenger Signs
The NO SMKG and SEAT BLTS control switches are located on the overhead panel in the flight
compartment. The control panel has three position (ON/OFF/AUTO) switches. When either switch
is turned ON, light for the no smoking or seat belt symbol illuminates.
When the NO SMKG switch is set to AUTO, the no smoking lights in the cabin illuminate
automatically when the landing gear is selected down or when cabin depressurization occurs
(cabin altitude greater than 8,000 ft).
When the SEAT BLTS switch is set to AUTO, the seat belt symbol in the cabin illuminates
automatically when the landing gear is selected down or the slats/flaps are not in the zero degree
position or when cabin depressurization occurs (cabin altitude greater than 8,000 ft).
Passenger Signs Electronic Chime
The chime will sound when the system operates automatically or if either the NO SMKG or SEAT
BLTS switch is selected to the ON position.
PAX SIGNS
CHIME
ELECTRONIC
GF1610_022
PASSENGER LIGHTING SYSTEM
Lighting is provided to illuminate the stairs which are part of the main passenger door, when entering
or exiting the airplane. The door stair lighting includes:
· Door stair lights (each step).
· Two stair ground lights (lower step).
· Passenger door rear light (if installed).
LIGHTING
REV 41, Jul 08, 2004 Flight Crew Operating Manual
CSP 700−6
Volume 2
16−10−17
PASSENGER LIGHTING SYSTEM (CONT'D)
Passenger/Crew Entrance Stair Lights
Entrance area lighting is provided to illuminate the stairs and area in front of the passenger door.
Lighting for the entrance area is provided by door stair lights. Each door stair light is installed in the
vertical part of the step. The lower folding step contains two door stair lights to supply light to the
area in front of the passenger door.
Each switch is normally
guarded. Guards are not shown to
illustrate each switch and label.
GF1610_023
NOTE
The stair lighting is controlled on and off by the “STAIRS” lights switch installed internally adjacent
to the main passenger door.
GF1610_024
LIGHTING
Flight Crew Operating Manual REV 41, Jul 08, 2004
CSP 700−6
Volume 2
16−10−18
PASSENGER LIGHTING SYSTEM (CONT'D)
Passenger/Crew Entrance Stair Lights (Cont’d)
The stair lights receive power when the passenger door “STAIRS” light switch is selected ON and
the passenger door is open. The door open signal is received from a switch located on the door
assembly. The “DOOR” switch is installed next to the “STAIRS” lights switch (both normally
guarded) and closing the door automatically shuts off the stair lighting.
SERVICE AND MAINTENANCE LIGHTING
The service and maintenance lights supply lighting to the work areas of the airplane for servicing,
maintenance and inspection purposes. The areas which illuminated are:
· Nose wheel well.
· Avionics compartments.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰者手冊7(93)