曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

CDI ±3/10 FSD (scale ±10 degrees).
Same as NDB except after the initial
splay, the splay is 2.86 degrees until
reaching an en route fix.
CDI ±1/2 FSD up to 51 NM and beyond 51
NM CDI ±2/5 FSD (scale ±10 degrees).
Like the NDB, the farther you are from the
VOR, the more the signal diverges. The
airway primary width is 4 NM either side of
centerline to 51 NM. From 51 NM to the
maximum standard service volume of 130
NM, the primary protected airspace splays
at 4.5 degrees.
CDI ±1/2 FSD (scale ±10 degrees).
The maximum standard service
volume for a T VOR is 25 NM. The
feeder route width is ±4 NM.
N/A N/A CDI ± 3/4 FSD for both lateral and
vertical.
The standard service volume for a
localizer is 18 NM. The localizer total
width at 18 NM is ±2.78 NM from
centerline and tapers to approximately ±5,000 feet from centerline at
the FAF.
The standard service volume for the
glide slope is 10 NM.
Figure B-5. Cockpit Indications and Tolerances to Keep You Within Protected Airspace. (Continued on Pages B-8 and B-9)
B-7
Phase of Flight
FINAL APPROACH MISSED APPROACH HOLDING
RMI ±10 degrees. If flown “FROM” the NDB, RMI ±5 degrees at
the visual descent point (VDP) or equivalent for a normal landing.
The course width for an approach with a FAF may be as small as
2.5 NM at the NDB and as wide as 5 NM at 15 NM from the NDB.
For an on-airport facility, no FAF approach, the course width
tapers from 6 NM (10 NM from the NDB) to 2.5 NM at the
MAP/NDB.
RMI ±10 degrees.
The course width widens to ±4
NM at 15 NM from the MAP.
RMI ±5 degrees.
Intersections – the size of
protected airspace varies
with the distance from the
NAVAID. See Figure 3-27
on page 3-23.
CDI ±3/4 FSD. If flown “FROM” the VOR, CDI ±1/2 FSD at the
VDP or equivalent for a normal landing (scale ±10 degrees).
The course width for an approach with a FAF may be as small as
2.0 NM at the VOR and as wide as 5 NM at 30 NM from the
VOR. For an on airport facility no FAF approach, the course width
tapers from 6 NM (10 NM from the VOR) to 2.0 NM at the
MAP/VOR.
CDI ±3/4 FSD (scale ±10
degrees).
For both FAF and no FAF
approaches, the course width
widens to 4 NM at 15 NM from
the MAP.
CDI ±1/2 FSD (scale ±10
degrees).
Intersections – the size of
protected airspace varies with
the distance from the NAVAIDs
that form the holding fix. See
Figure 3-27 on page 3-23.
CAT I CDI ±3/4 FSD for localizer and glidepath at the glide slope
intercept. CDI ±1/2 FSD at the DA point for a normal landing.
(scale total width may vary from 3 to 6 degrees).
The normal length of final is 5 NM from the threshold. The final
approach obstacle clearance area width at the FAF is approximately ±5,000 feet from centerline and tapers to as small as
±500 feet from centerline at 200 feet from the runway threshold.
The CAT I final approach OCS can be as small as 500 feet below
glidepath at the FAF. At a DA point located 3,000 feet from the
threshold, the OCS may be as close as 114 feet below the
glidepath.
Decision range for airplane CAT II CDI ±1/6 FSD for localizer and
±1/4 FSD for glidepath and for helicopter ±1/4 FSD for localizer
and glidepath. The tracking performance parameters within the
decision range (that portion of the approach between 300 feet
AGL and DH) are maximums, with no sustained oscillations
about the localizer or glidepath. If the tracking performance is
outside of these parameters while within the decision region,
execute a go-around since the overall tracking performance is
not sufficient to ensure that the aircraft will arrive at the DH on a
flight path that permits the landing to be safely completed.
N/A N/A
B-8
Phase of Flight
CDI centered when departing the runway to
the IDF with a maximum of ±3/4 FSD upon
reaching the terminal route (CDI scale
±1NM).
The HAL in the terminal mode is 1 NM.
NAVAID DEPARTURE EN ROUTE TERMINAL
GPS
(C-129A)
WAAS
LPV
CDI centered when departing the runway
with a maximum of ±3/4 FSD upon reaching
the terminal route (scale ± 1NM).
For departures, the climb area protected
airspace initially splays at 15 degrees from
the ±500-foot width either side of centerline
at the DER to a nominal distance of 2 NM
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Instrument Procedures Handbook (IPH)儀表程序手冊下(174)