TASK 31-31-03-402-037
 7. Flight Data Acquisition Unit (FDAU) Software Installation with the use of the
_____________________________________________________________________________ Teledyne PCMCIA Interface
_________________________
 A. General
 (1)  
This procedure tells you how to install software in the flight data acquisition unit (FDAU) with the use of a personal computer memory card international association (PCMCIA) interface.

 (2)  
The FADU must contain these pieces of software:

 (a)  
mandatory FDAU software

 (b)  
ACMS non-mandatory FDAU software

 (3)  
A PCMCIA data card is required for this procedure.

 (4)  
The airplane must be on the ground with the engines shut down before you can install software.

 B. Reference
 (1)  AMM 24-22-00/201, Electrical Power Control
  ú

 31-31-03
 ALL  ú ú 06 Page 214 ú Sep 28/01

A

757
MAINTENANCE MANUAL

 C.  Access
 (1)  Access Panel
 119BL Main Equipment Center, E3-3

 D.  Procedure
 S 862-038
 (1)  
Do this task: Supply Electrical Power (AMM 24-22-00/201).

 S 012-039

 (2)  
Do these steps to prepare for the software installation:

 (a)  
Make sure you know the correct software part number for the FDAU. For the FDAU to be an approved installation, the correct software part number must be installed.

 (b)  
Make sure the system select switch on the data loader control panel (P61) is set to NORMAL.

 S 202-040
 (3)  Make sure that these circuit breakers are open:
 (a)  Circuit Breaker Panel, P11:
 1) 11J7, FLIGHT RECORDER AC
 2) 11J8, FLIGHT RECORDER DC

 S 412-041
 (4)  Do these steps to install the software.
 (a)  
Put the PCMCIA card into the FDAU PCMCIA slot.

 (b)  
Make sure that these circuit breakers are closed:

 NOTE: With the correct upload disk in the FDAU, the software
____ loading should be completed in less than 3 minutes.
 1)  Circuit Breaker Panel, P11:
 a) 11J7, FLIGHT RECORDER AC
 b) 11J8, FLIGHT RECORDER DC

 (c)  Do these steps on the FDAU to monitor the loading process: 1) Push ESC key until TELEDYNE CNTRLS show on the FDAU
 display. 2) Push ENT key to show MANDATORY MENU. 3) Push (+) to show NON-MANDATORY MENU. 4) Push ENT to show VERSION. 5) Push (+) two times to show LOAD STATUS. 6) Push ENT. 7) Make sure Erasing, Programming, Complete or Remove PC-Card
 instructions shows as the software loading proceeds through different states of the loading.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 1(121)