30-41-01
 ALL  ú ú 03 Page 402 ú May 28/99

A

757
MAINTENANCE MANUAL

 S 864-012
 (2)  If you installed the heat control unit, M191, for the left forward/right side window do these steps:
 (a)  Remove the DO-NOT-CLOSE tags and close these circuit breakers on the P70 panel: 1) 70C13, WINDOW HTR L 2) 70A3, WINDOW HTR 2R 3) 70A4, WINDOW HTR 3R (70A4)
 S 864-014
 (3)  If you installed the heat control unit, M192, for the right forward/left side window do this step:
 (a)  Remove the DO-NOT-CLOSE tags and close these circuit breakers on the P37 panel: 1) 37E3, WINDOW HTR 2L 2) 37E4, WINDOW HTR 3L 3) 37J2, WINDOW HTR 1R
 S 714-015
 (4)  Do a test on the installation of the heat control unit:
 (a)  
Supply electrical power to the main AC buses
 (AMM 24-22-00/201).

 (b)  
Push the BIT/VERIFY switch on the heat control unit.

 (c)  
Make sure the TEST COMPLETE light on control unit comes on after about 2 |0.5 seconds and stays on approximately 20 seconds.

 (d)  
Close the E/E bay access door 119BL (AMM 06-41-00/201).

 (e)  
Remove electrical power if it is not necessary
 (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 30-41-01
 ALL  ú ú 03 Page 403 ú May 28/99

A

757
MAINTENANCE MANUAL

 WINDOW HEAT CONTROL PANEL - REMOVAL/INSTALLATION
________________________________________________
 1.  General
_______
 A.  This procedure contains two tasks. The first task is the removal of the window heat control panel, M10395. The second task is the installation of the window heat control panel, M10395.
 B.  The window heat control panel is on the pilots' overhead panel, P5. In this procedure, the window heat control panel is referred to as the control panel.
 TASK 30-41-02-004-001
 2.  Remove the Control Panel
________________________
 A.  References
 (1)  AMM 24-22-00/201, Electrical Power - Control
 B.  Access
 (1)  Location Zones
 211/212 Control Cabin - Section 41
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 防冰和排雨 CHAPTER 30 - ICE AND RAIN PROTECTION(126)