.
Level 2 — Identifies all failures currently within the system. Level 2 is accessed by maintenance personnel to help resolve INOP conditions.
.
Level 3 — Identifies the configuration status of the Warning Computer and the installation.
.
Level 4 — Identifies faults that have occurred during past flights. This information can be used to resolve system problems reported by the flight crews.
.
Level 5 — Identifies alerts that have occurred during past flights. This information can be used to resolve system problems reported by the flight crews.
.
Level 6 — Identifies state changes in the input discretes. This information can be used to verify the installation and proper function of all discrete inputs.
Self-Test aural is heard over the cockpit speaker, cockpit interphone system, or through the headphone jack on the EGPWC front panel (MK V and MK VII only). Details of these Self-Test levels are provided in Fault Isolation section
3.
3 FAULT ISOLATION (TROUBLESHOOTING)
3.1 GENERAL
The troubleshooting methods provided in this section identify system and sensor or subsystem faults to the lowest level possible. Additional fault isolation in the installation or associated sensors or subsystem should be performed using the aircraft installation and wiring diagrams and other supporting documentation in accordance with established maintenance procedures.
Do not remove or replace the EGPWC until all associated sensors or subsystems and their interfaces have been verified per established maintenance procedures and the fault is isolated to the EGPWC. If the troubleshooting methods determine that the EGPWC is faulty, then the EGPWC should be replaced per Section 6. Route the faulty EGPWC to an authorized repair facility for repair.
3.2 TROUBLESHOOTING GUIDE
In general, if any EGPWS Inoperative status is indicated, the EGPWC front panel LED’s should be checked. The following table shows the recommended maintenance action in response to the front panel LED’s.
EXTERNAL FAULT COMPUTER OK COMPUTER FAIL CORRECTIVE ACTION
OFF GREEN OFF Normal operation.
YELLOW GREEN OFF Troubleshoot external faults using the Level 2 Self-Test. DO NOT REMOVE OR REPLACE THE EGPWC
OFF OFF OFF Ensure that the EGPWC is installed in the rack correctly and power to the EGPWC is turned on.
OFF OFF RED Record the Level 2 Self-Test, if possible. Remove and replace the EGPWC if required.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：增強型近地警告系統 Enhanced Ground Proximity Warning 航線維護手冊 Systems Line Maintenance Manual(20)
