曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Functional Description
When there is a reverse thrust command, hydraulic pressure from the directional control valve (DCV) is directed to the extend and retract sides of the actuator piston. The piston extends because the surface area of the piston on the extend side is larger than the retract side of the piston. This permits the actuators to move the thrust reverser sleeve to the extended position in 2-3 seconds.
When the thrust reversers are commanded to retract, hydraulic pressure from the DCV is directed to the retract side of the piston. Hydraulic fluid in the deploy side tubing is directed to the hydraulic return line through the DCV. The actuators will retract and stow the thrust reverser sleeve in 3-5 seconds.
Training Information Point
The non-locking actuators are interchangeable but the correct plugs and unions must be installed in the actuator hydraulic ports for the installation at the upper position, left or right thrust reverser half.

EFFECTIVITY BEJ ALL  78-34-00 
Page 35 
D633W101-BEJ  May 05/2003 

 

TRAS -NON-LOCKING HYDRAULIC ACTUATORS

Correct rigging of the thrust reverser actuators is done with the correct installation of the non-locking actuator. There are no adjustments that can be made after the actuators are installed. All adjustments to the actuators are made when the actuators are assembled at the fully retracted position per the component maintenance manual. Any adjustments to the actuators that are made during the installation, such as turning the actuator rod end changes the actuator length and can affect the operation of the thrust reverser actuation system. This can cause the thrust reverser sleeve to bind or jam, operate slowly, cause damage to the actuator or damage to the thrust reverser structure.
The retract side of the thrust reverser hydraulic actuation system must be pressurized when a non-locking actuator is installed. The hydraulic pressure will make sure all the hydraulic actuators are completely retracted and the bullnose seal is compressed to correctly rig the thrust reverser actuation system. Do not remove the hydraulic pressure while you install the actuator.
EFFECTIVITY BEJ ALL  78-34-00 
Page 36 
D633W101-BEJ  May 05/2003 

PW4000 SERIES ENGINES

 

777 AIRCRAFT MAINTENANCE MANUAL

 

TRAS -NON-LOCKING HYDRAULIC ACTUATORS

EFFECTIVITY BEJ ALL  78-34-00 
Page 37 
D633W101-BEJ  May 05/2003 

PW4000 SERIES ENGINES

 

777 AIRCRAFT MAINTENANCE MANUAL

THIS PAGE IS INTENTIONALLY LEFT BLANK

78-34-00

Page 38 D633W101-BEJ May 05/2003

TRAS -REVERSE THRUST LEVER INTERLOCK ACTUATOR

Purpose

The reverse thrust lever interlock actuator releases the reverse interlock which keeps the engine thrust command at idle until the thrust reverser (T/R) sleeves get near the extended position.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 發動機排氣 Engine Exhaust PW 777 AIRCRAFT MAINTENANCE MANUAL(40)