曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

In the hinge fitting, the barrel nut has a self-locking feature that can become worn.The barrel nut is held in the hinge fitting with a retainer.The retainer fits on the flat surface of the barrel nut.The curved part of the retainer has a raised top that indexes the retainer to the hole for the hinge bolt in the hinge fitting. The barrel nut and retainer can be replaced.
Training Point Information
You must open the thrust reverser to get access to the hinge components and the pressure relief latches for the door.
Ground support equipment is used to determine if the pressure relief latches operate at the correct load.

EFFECTIVITY BEJ ALL  78-31-00 
Page 50 
D633W101-BEJ  Jan 05/2004 

 

THRUST REVERSER PRESSURE RELIEF DOORS

EFFECTIVITY BEJ ALL  78-31-00 
Page 51 
D633W101-BEJ  Jan 05/2004 

PW4000 SERIES ENGINES

 

777 AIRCRAFT MAINTENANCE MANUAL

THIS PAGE IS INTENTIONALLY LEFT BLANK

78-34-00

Page 1 D633W101-BEJ Sep 05/2002

THRUST REVERSER ACTUATION SYSTEM (TRAS) -INTRODUCTION
General

The thrust reverser actuation system (TRAS) supplies hydraulic power to extend or retract the T/R sleeves.
EFFECTIVITY BEJ ALL  78-34-00 
Page 2 
D633W101-BEJ  Sep 05/2002 

 

THRUST REVERSER ACTUATION SYSTEM (TRAS) -INTRODUCTION

EFFECTIVITY BEJ ALL  78-34-00 
Page 3 
D633W101-BEJ  Sep 05/2002 

PW4000 SERIES ENGINES

 

777 AIRCRAFT MAINTENANCE MANUAL

THIS PAGE IS INTENTIONALLY LEFT BLANK

78-34-00

Page 4 D633W101-BEJ Sep 05/2002

TRAS -GENERAL DESCRIPTION

General

The thrust reverser actuation system (TRAS) supplies hydraulic power to move the thrust reverser sleeves. It operates on the ground only.
The TRAS uses hydraulic power for operation and electrical power for control.
The TRAS uses these valves to control hydraulic pressure to the hydraulic actuators:
*
Sync lock valve (SLV)

*
Isolation valve (IV)

*
Directional control valve (DCV).

The hydraulic actuators move the thrust reverser sleeves.

The sync shafts keep the movement of the actuators together. They also permit manual operation of the thrust reverser sleeves for maintenance.
The sync lock/manual drive units lock the sync shafts in the retracted position.
EFFECTIVITY BEJ ALL
The reverse thrust lever interlock actuator prevents the maximum reverse thrust command until the thrust reverser sleeves get near the extended position. The electronic engine control (EEC) uses thrust reverser sleeve position data from the rotary variable differential transducers (RVDTs) to control the interlock actuator.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 發動機排氣 Engine Exhaust PW 777 AIRCRAFT MAINTENANCE MANUAL(26)