曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

EFFECTIVITY BEJ ALL
A lead mechanic, positioned approximately 8-10 feet behind the power plant, can observe the level of the power plant and cradle and the rate that the hoists are being operated. The lead mechanic can then instruct which mechanics at each of the hoists to stop operating their hoist while the other hoists catch-up to keep the cradle level. The lead mechanic can also watch the engagement of the forward and aft engine mounts and the strut and instruct which hoist is to be operated.
Lift the engine until there is approximately 6-8 inches between the forward and aft engine mounts and the strut. Use the forward bootstrap hoists to change the roll angle of the power plant so that the engine mounts can align with the strut. Use the forward and aft hoists to adjust the engine pitch.
Slowly continue to lift the power plant engage the alignment shear pins in the forward engine mount from the strut and the aft engine mount from the alignment shear pins in the strut. After the shear pins are engaged, continue to lift the power plant so that the engine mounts come in contact and engage the strut. No gaps are allowed between the mounts and the strut. Watch the loads on the dynamometers are not more than the limits. Install the engine mount bolts and tighten to the correct torque.
Make sure the engine mount bolts hold the power plant to the strut. Reduce the load on the hoists and make sure there are no gaps at the engine mounts. If a there is a gap, load the bootstrap hoists again and retighten the engine mount bolts.
71-00-00

Page 17 D633W101-BEJ May 05/2003

TIP -POWER PLANT REMOVAL AND INSTALLATION
Refer to the AMM Chapter 71 for the power plant installation procedure.
EFFECTIVITY BEJ ALL  71-00-00 
Page 18 
D633W101-BEJ  May 05/2003 

PW4000 SERIES ENGINES

777 AIRCRAFT MAINTENANCE MANUAL

BOOTSTRAP EQUIPMENT

EFFECTIVITY BEJ ALL  71-00-00 
Page 19 
D633W101-BEJ  May 05/2003 

TIP -THRUST REVERSER HOLD-OPEN EQUIPMENT

Normally when you open the thrust reverser (T/R) halves, you attach hold-open rods to the engine to hold the T/R halves open. When you change an engine, you must attach special T/R hold-open equipment to the strut to hold the T/R halves open.
CAUTION:  MAKE SURE THE LEADING EDGE SLATS ARE RETRACTED AND DEACTIVATED BEFORE YOU OPEN THE THRUST REVERSERS MORE THAN THE 37 DEGREE POSITION. WHEN THE THRUST REVERSERS ARE OPEN MORE THAN 37 DEGREES, THE LEADING EDGE SLATS WHEN EXTENDED CAN TOUCH THE THRUST REVERSERS. IF YOU DO NOT OBEY THIS INSTRUCTION, DAMAGE TO THE LEADING EDGE SLATS AND THRUST REVERSERS CAN OCCUR.
Hold-Open Extension Adapter
To install the T/R hold-open tools you must open the T/Rs to 45 degrees. But, with the forward hold-open rods connected to their standard fan case fittings, the T/Rs will not open that far. You must install hold-open extension adapters.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 動力裝置 Power Plant PW 777 AIRCRAFT MAINTENANCE MANUAL(8)