曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Figure 310 Eccentric Roller End Pattern - Reject .................................................................................. 321
Figure 311 Excessive Pitting Pattern - Reject........................................................................................322
Figure 312 Excessive Scuffing Pattern - Reject.....................................................................................323
Figure 313 Wide Band Roller Contact Pattern ....................................................................................... 325
Figure 314 Polishing............................................................................................................................... 326
Figure 315 Unacceptable Cage Defects ................................................................................................ 327
Figure 316 Cage Defects........................................................................................................................ 328
Figure 317 Cage Defects........................................................................................................................ 329
Figure 318 Bearing Analyzer Model BA-20-3......................................................................................... 331
Figure 319 Typical Spline Wear Patterns and Locations ....................................................................... 333
Figure 320 Check of Curvic Coupling Tooth Bearing Pattern ................................................................ 340
Figure 321 Runout and Tooth Bearing Pattern Check (Curvic Coupling Nomenclatures and

Seal Cavity Dimensions) ...................................................................................................... 342 Figure 322 Runout and Tooth Bearing Pattern Check  (Gable Angle Dimensions and
Master Control Coupling Set-up Inspection Specifications) ................................................ 344 Figure 323 Runout and Tooth Bearing Pattern Check (Inspection Specifications for
Single Curvic Couplings)......................................................................................................346 Figure 324 Runout and Tooth Bearing Pattern Check (Inspection Specifications for
Parts with Two Curvic Couplings) ........................................................................................ 347

Page TC-7
Apr 1/05
20-00-02/70-00-01

Copying, use or disclosure of information on this page is subject to proprietary restrictions.

FIGURE PAGE
Figure 325 Runout and Tooth Bearing Pattern Check (Full Tooth Bearing Pattern
Acceptance Specifications)..................................................................................................349 Figure 326 Runout and Tooth Bearing Pattern Check (Localized Tooth Bearing Pattern
Acceptance Specifications)..................................................................................................350
Figure 327 Bubble Point Test Diagram .................................................................................................. 354
Figure 328 Test Setup of Filter Elements...............................................................................................355
Figure 329 Test Setup of Thermocouple Simulation..............................................................................357
Figure 330 Typical Thermocouple Installation ....................................................................................... 358
Figure 331 Uncompensated Cold Junction Thermocouple Simulation..................................................359
Figure 401 Touch-Up Application...........................................................................................................420
Figure 402 Touch-Up Results ................................................................................................................ 420
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：標準施工手冊 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(13)