(b)
Disconnectthe linefromthe backof the pressuregauge.
(c)
Loosenand removethe retainernut andclampholdingthegaugein place.
(d)
Pullthe gauge out from the frontof the panel.
10. PressureGaugeInstallation
(a)
Placethe gaugeintothe panelfromthefront andreplacethe clampand retainernuton the back of the gauge. Be surethe gaugeis positionedproperlybeforetighteningthe clamp.
(b)
Reconnectthe lineat the rearof thegauge.
11. SurgeValveRemoval(referto Figure402)
(a)
Closethe controlvalveanddepressurizethe oxygensystemas required.
(b)
Removethe surge valve.
(c)
Checkthe operationof the system. If a malfunctionof surgevalveis found,disassemblethe valveto the extent of removalof a defectivepart (diaphragm,O-ring,or spring).
(d)
Inspectthe filter in the inlet port. If required, cleanthe assembledbodyand sinteredfilterin an ultrasoniccleaner. Ensurethat detailpartsdo not comeintocontactwith hydrocarbon-based
materials(solvents,oil, grease,etc).
(e)
Reassembleusing newO-ringand serviceablereplacementpartsas required.
EFFECTIVITY:
040-999
Jan10/9035-10-00
PIPER AIRCRAFT
PA-42-720(AdvancedTrainer)
MAINTENANCEMANUAL
A. Maintenance Practices (continued)
12. Surge Valve Installation (refer to Figure 402)
(a)
Installthe surge valve.
(b)
Pressurizeand test the system for leaks.
1. Spring
DiaphragmPlate
6.
Body
7.
Filter
SurgeValve (Cross Section) Figure 402
13. Outlet Removal
(a)
Using a suitablespannerwrench,remove the outerhalfof the outlet.
(b)
Removethe screws holdingthetrim panel and remove the panel.
(c)
Theoutlet can now be removedfrom the low pressure line.
14. Outlet Installation
(a)
ApplyPermacel#412 ribbondopethreadsealantto the maleendof the fitting.
(b)
Connectthe outlet to the lowerpressureline.
(c)
Positionthe trim panel and securewith screws.
(d)
Positionthe outer half outlet and securewith a suitable spanner wrench.
(e)
Tightenthe fittings into the outletsto a torque of approximately 30 inch-pounds.Do not overtightenfittingsas this coulddamage the outlet.
EFFECTIVITY:
040-999 PAGE 5
35-10-00 Jan10/90
PIPERAIRCRAFT
PA-42-720(AdvancedTrainer)
MAINTENANCEMANUAL
A. MaintenancePractices(continued)
15.OxygenPlumbing Replacement (referto Figure 403)
Thefollowingprovidesinformationon installation ofoxygenplumbinglinesif rigid tubing mustbe installed,especiallyif relocation is required. Safetylimitationsaredescribedin the rulesnoted below.
(a)
All installed oxygenplumbingmust be above andat least 6 inches from all hydraulic andfuel plumbing.
(b)
Theremustbe at least two inches minimumclearancebetweenall oxygen plumbingand componentsand any aircraftmovingpartsinareas where fuel or hydraulicplumbingand electrical wiring exist.Alloxygenplumbingand components mustbeat least 12 inches from primaryflight controls and engine controls.
(c)
Wherepossible,alloxygenplumbingand components mustbe at least 6 inches from electrical wiringandcomponents.Whereit is not possibleto maintain 6 inches clearance, a2 inch clearanceis acceptable providedthe wire bundlesaresupportedin conduit or with closely spacedclampsor clips. Where2 inch clearanceis not possible, boththe wiring andthe oxygen componentsmust be protected withadditionalinsulationand supported insucha manner that they cannot be deflectedto within 1 1/2 inch of each other.
(d)
Maintaina minimum clearanceof 1/8 inch between oxygentubingandthe structure adjoining thesupportingclamp(See sketch A).
(e)
All low pressure oxygenlines must maintaina minimum clearanceof 1/8 inch to prevent contact with anotherobject(nut, bolt, bracket,etc.) when sufficiently supported.Thesame holds true for high pressure lines,excepthighpressuremust maintain 1/2inch min imum slearance(See sketch B).
(f)
Wherean oxygen tubepassesthroughagrommet,thetubemust not bear on the grommetin any way to cause the grommet to cut in service (Seesketch C).
1/8"min.
1/8" min.
1/2" min (Low Pressure)
1/8"min. 1/8"min. (HighPressure)SKETCH B
GROMMETGROMMET (SEE ITEM 5)
SKETCH A
(SEEITEM4)
CORRECT INCORRECT
SKETCHC (SEEITEM6)
OxygenTubingInstallations
Figure 403
EFFECTIVITY:
040-999
Jan10/9035-10-00
PIPER AIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCE MANUAL
A. MaintenancePractices(continued)
16. Cleaning
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：夏延飛機維護手冊 Cheyenne IIIA PA-42-720 AMM 2(82)
