S 285-007
(5)
Make sure these systems are operational:
(a)
EFIS (AMM 34-22-00/501).
(b)
EICAS (AMM 31-41-00/201).
S 285-008
(6)
Make sure these switches are in the correct positions:
(a)
Make sure the IRS and EFI switches on the instrument source select panel P1 (P3) are in the usual position (ALTN legend not displayed).
(b)
Put the L, R, and C IRS mode select switches on the inertial reference mode panel P5 in the NAV position (Ref 34-21-00/501).
E.
Stall Warning System Operational Test (Fig. 501, 502)
NOTE: Make sure you do the tests for both the left and the right systems
____ if these procedures are being done for scheduled maintenance checks.
S 015-215
(1) Open the EE bay access panel 119BL to see the WEU BITE.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-32-00
ALL ú ú 02A Page 502 ú Sep 20/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
Component Location
Figure 501
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-32-00
ALL ú ú 02A Page 503 ú Sep 20/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
EADI, N44 (REF)
SEE C EADI, N4 (REF) P11 PANELSEE C
MISC TEST PNL, M10398 (REF)
SEE B
MAIN EQUIP CTR ACCESS, 119BL
CONTROL COLUMN (REF) FLT COMPT SEE A
CONTROL COLUMN
TEST (REF)
AIR DATA CONFIG L CMPTR R T/O GND PROX
STALL TEST
CAPT OR F/O SWITCH (S1)(S2) L STALL R LDG INOP
CONTROL COLUMN WING DUCT YAW DMPR EQUIP COOL
SHAKER, M240 ANTI ICE LEAK L FWD
OR M952
WINDOW/ FUEL R AFT FWD PROBE HEAT QTY
CONTROL COLUMN (REF)
WINDSHEAR
PITCH LIMIT MISC TEST PANEL, M10398 (REF)
A
INDICATOR
B
105 00FT DH100 GS250
1750
F
S
A/T SPD
CMD FLARE
ROLLOUT G/S
LOC
ELEX ATTITUDE DIRECTION INDICATOR (EADI)
C
Component Location
Figure 502
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-32-00
ALL ú ú 02A Page 504 ú Sep 20/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
S 215-090
CAUTION:_______ MAKE SURE THE MOVEMENT OF THE SLATS DOES NOT HIT OR CATCH THE
ACCESS DOOR FOR THE ENGINE STRUT, THE INBOARD FAN COWLING, AND
THE THRUST REVERSER COWLING. IF THE MOVEMENT OF THE SLATS IS
BLOCKED, IT CAN CAUSE DAMAGE TO THE AIRPLANE.
(2)
Make sure the movement of the leading edge slats does not catch or hit these panels (AMM 71-11-04/201):
(a)
The access doors for the left and right engine struts.
(b)
The inboard fan cowling on the left and right engines.
(c)
The thrust reverser cowling on the left and right engines.
S 745-200
WARNING: KEEP PERSONS AND EQUIPMENT AWAY FROM ALL CONTROL SURFACES WHEN
_______ HYDRAULIC POWER IS SUPPLIED. AILERONS, ELEVATORS, RUDDER, FLAPS, SLATS, SPOILERS, AND STABILIZER ARE FULLY POWERED SURFACES. OPERATION OF STALL WARNING TEST SWITCHES CAN CAUSE THE SLATS TO MOVE TO THEIR FULLY EXTENDED POSITION. INJURY TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR WHEN HYDRAULIC POWER IS SUPPLIED.
(3) Hold down the L STALL (R STALL) TEST switch on the right side panel, P61.
S 285-010
(4) Make sure you find these conditions: (a) The L (R) stick shaker and both columns shake. (b) The Windshear Pitch Limit indicator (PLI) shows on the L (R) EADI.
(c) (d) On the WEU BITE Module (P51), all segments on the LEFT (RIGHT) stall hex display come on, and the code D9 shows on the opposite RIGHT (LEFT) stall hex display.The EICAS status message WARN ELEX shows.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(139)
