D.  Procedure
 S 012-002
 (1)  
Remove the floor coverings from the floor if it is necessary (AMM 25-27-02/401).

 S 112-003

 (2)  
Clean the floor, seat track slots and other surfaces you will seal (AMM 51-31-01/201).

 (3)  
Do a check of the painted floor panels for damage.

 (4)  
Paint the floor panels if it is necessary.

 S 342-006

 (5)  
Do a check of the splashguard and splashguard retainer for the correct seal.

 S 212-004
 S 372-005
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-32-00
 ALL  ú ú 05 Page 201 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
COVER PLATE
SEE

BMS 5-95 SEALANT BMS 5-95 SEALANT INSPECT AND RESEAL INSPECT AND RESEAL AS NECESSARYAS NECESSARY
UPPER DECK GALLEY FLOOR SEALING
A-A

Upper Deck Galleys
Figure 201

D17648
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-32-00
 ALL  ú ú 03 Page 202 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (6)  S 342-010Seal the joints of the splashguard with BMS 5-95 if it is necessary.
 (7)  S 342-016Seal the spaces between the splash guards per BAC 5010, Type 60.
 (8)  S 022-017Remove the bolts from the floor attach fittings.
 (9)  S 212-011Do a visual check of the bolt and the attach fitting for damage or unwanted material.
 S 162-012

 (10)
 Clean the bolt and the attach fitting if it is necessary.

 S 422-018

 (11)
 Install the bolt with a layer of BMS 5-95 sealant or BMS 3-24 grease.

 NOTE: Apply a layer of sealant or BMS 3-24, grease to the bolt,
____ and put the bolt into the hole. Tighten the bolt before the sealant becomes dry.
 S 342-008
 (12)
 Repair the water barrier, if it is necessary (AMM 53-21-02/401).

 S 412-009

 (13)
 Install the floor covering (AMM 25-27-02/401).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-32-00
 ALL  ú ú 01 Page 203 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 UPPER DECK GALLEYS - ADJUSTMENT/TEST
____________________________________
 1.  General_______
 A.  This procedure gives the instructions to do the serviceable test of the installed galley system on the upper deck.
 B.  Do the subsequent two tests at the same time. Do a test of the electrical system for the galley. An incorrect operation will cause the control bus switches or circuit breakers for the galley to open. Do a check of the specified system to find the cause of the open circuit.
 C.  The primary power centers supply electrical power to the galley through four bus feeders. Some bus feeders are divided between two galley complexes. Each galley complex feeder has a switch to remove electrical power in an emergency. The switch(s) for emergency power must be ON in the two complexes to have power at one or two complexes. For the galley power supply, refer to AMM 25-31-04/401 Main Deck Galleys and AMM 24-51-00/001 115-volt AC Power Distribution Systems.
 D.  The location of the shutoff valve for the galley water system is in the top of the galley structure. The location of the electrical control panels is on the face of the top galley structure.
 E.  The test of the galley ventilation system is part of the airplane system test.
 TASK 25-32-00-705-001
 2.  Upper Deck Galley Operational Test__________________________________
 A.  References
 (1)  
AMM 12-14-01/301, Water System

 (2)  
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(87)