曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 C.  The FCC is the primary computing component for the AFDS. It provides Autopilot (A/P) commands to the servos that move the control surfaces, Flight Director (F/D) commands to the PFD to direct manual pilot control, and system monitoring and fault detection for the CMCS.
 D.  The AFCS MCP is in the autopilot system to provide flight crew inputs for control of the autopilot/flight director and autothrottle functions. The control panel allows the pilots to: engage the autopilots, arm/disarm the autothrottle, turn the flight directors ON or OFF, control airspeed, control vertical speed, select altitude and heading, arm/disarm the localizer and approach modes, and select the Flight Management Computer (FMC) as the source for vertical and lateral navigation control.
 E.  The location of the primary AFDS components are shown in Figure 1.
 2.  Flight Control Computer (FCC)_______________________
 A.  The left, center, and right FCCs are identical and contain all logic and signal handling circuitry for direct pitch axis control (elevators and stabilizer trim), roll axis control (ailerons), and yaw axis control (rudders). Yaw control is active only during a multi-channel approach and rollout.
 B.  Each FCC provides autopilot command output signals which drive hydraulic servos that deflect the control surfaces. Each FCC also provides flight director data to the Electronics Interface Units (EIUs) for steering commands and mode annunciation display on the PFDs.
 C.  FCC program pin connections are permanently wired at the shelf connector. The pin connections provide inputs to the FCC, which allow the selection of the configuration options. These pin connections can be checked by a CMC ground test in the < 22 AUTOPILOT FLT DIR test group. The test is FCC CONFIGURATION. The CMC displays the decimal value of the bit pattern created by the grounded and open pins in each option group. The following is a list of the options and functions the program pins control.
 (1)  AIRCRAFT
 (a)  Five pin connections provide 32 combinations at the FCC shelf for identifying the aircraft type. The FCC reads these pins as a binary code.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 01 Page 1 ú Oct 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

ROLLOUT POWER CONTROL PACKAGES (AMM 22-13-00/001)
STABILIZER TRIM CONTROL MODULES (AMM 22-22-00/001)
ELEVATOR AUTOPILOT SERVOS (AMM 22-12-00/001)
FLIGHT
COMPARTMENT

SEE A
CENTRAL LATERAL CONTROL PACKAGES
MAIN EQUIPMENT AND LATERAL A/P SERVOCENTER
(AMM 22-13-00/001)
SEE B

GLARESHIELD, P10
. MODE CONTROL PANEL

SEE D
FIRST OFFICER'S PANEL, P3 . PFD . ND
UPPER EICAS DISPLAY  SEE E
CAPTAIN'S PANEL, P1 INSTRUMENT SOURCE
.  PFD SELECT SWITCHES
.  ND
SEE E

INSTRUMENT SOURCE SELECT SWITCHES
CONTROL WHEELS 
A/P DISENGAGE 
.  SWITCHES 
THRUST LEVERS (2 AND 3)  SEE  F 
. GO AROUND SWITCHES 
SEE  G 
FLIGHT COMPARTMENT 
A 

Autopilot/Flight Director System - Component Location
Figure 1 (Sheet 1)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 01 Page 2 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 

20  0 

2 7  0 

5
25
SELTHR
V NAV
DN
LOC
BANK
AUTO
SEL
OFF
OFF
LIMIT
SPD FL CH HOLD
V/S
HOLD APP DISENGAGE
UP
MODE CONTROL PANEL (P10)

Autopilot/Flight Director System - Component Locations
Figure 1 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-10-00
 ALL  ú ú 01 Page 3 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 空調 AUTO FLIGHT(19)